Hama TV Wall Bracket

Product Information

Brand: Hama

Model Numbers: R1118166, R1118169

Product Type: TV Wall Bracket

Specifications

Package Contents

• TV wall bracket
• TV support arms (2x)
• Drilling template
• Cable ties
• Installation kit (see Fig. 1)
• Operating instructions

Note: Please check that the installation kit is complete and that no parts are faulty or damaged before installation.

Safety Notes

Warning:

• This product is suitable for wall mounting only.
• Ensure the wall is suitable for the weight and that there are no electrical wires, water, gas, or other lines at the installation location.
• The supplied wall plugs are for concrete and solid brick walls only.
• Never apply force during mounting.
• If in doubt, have this product mounted by a qualified technician.
• Do not mount the product above locations where persons might linger.
• Check the mounting periodically (at least every three months) for security and safety.
• Do not exceed the maximum load bearing capacity.
• Ensure the product is loaded symmetrically.
• Maintain necessary safety clearance around the attached load.
• In case of damage, remove the load and stop using the product.

Note:

• Given the multitude of terminal devices and wall structures, the supplied mounting kit may not cover all options.
• Screws for attaching the terminal device may be too long in some cases.
• Read the operating instructions for your terminal device before mounting.
• If the supplied mounting kit does not contain suitable fastening materials, purchase them from a specialized dealer.
• If the wall is made of different material types, purchase suitable mounting materials from a specialized dealer.

Installation Requirements and Installation

Note:

• Only mount the TV wall bracket with the help of a second person.
• Ensure that necessary connections on the TV will still be accessible after installation.
• The mounting kit is universal; not all parts may be needed for your specific installation. Keep leftover parts for future use.

Installation Steps (Refer to Figures):

1. Prepare the bracket: Attach the support arms (F2) to the wall plate (F1) using screws (B1, C1, D1, D2, D3, D4) and washers (B2, B3) as needed, depending on the TV's back panel (flat or curved). Use the correct screws and washers as indicated in Figure 4.
2. Mark drilling points: Use the drilling template to mark the positions for the holes on the wall. Ensure the wall plate is level.
3. Drill holes and insert anchors: Drill holes of the specified diameter (e.g., 10 mm) and insert the appropriate wall anchors (A1, A2, A3) if required for your wall type.
4. Mount the wall plate: Attach the wall plate to the wall using the appropriate screws (e.g., A1, A2, A3).
5. Attach the TV to the support arms: Mount the support arms to the back of the TV using the screws (C1, C2, D1, D2, D3, D4) and spacers (B2, B3) if needed to ensure the bracket sits flat.
6. Hang the TV on the wall plate: Lift the TV with the attached support arms and hang them onto the wall plate. Secure the TV by pulling the safety cord downwards and letting it snap into place (Fig. 5).

Setting and Maintenance

Note:

• Adjust the TV wall bracket with the help of a second person.
• Screws do not need to be loosened to adjust the angle.
• Check the bracket's security and safety at regular intervals (at least every three months).
• Clean the bracket using only water or standard household cleaners.

Intended Use

This bracket is intended for wall mounting flat panel displays for non-commercial, private household use within buildings.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation, mounting, improper use of the product, or failure to observe the operating instructions and/or safety notes.

Service & Support

Hama GmbH & Co KG

86652 Monheim / Germany

Website: www.hama.com

Phone: +49 9091 502-0