JONSBO CR-1400 DV2 Series CPU Cooler User's Manual

For your real needs

Chapter 1 - Part List

The JONSBO CR-1400 DV2 Series CPU Cooler package includes the following components:

A. CPU Heatsink: The primary cooling component designed to dissipate heat from the CPU.
B. Backplate - Intel: A support plate used for installing the cooler on Intel motherboards, specifically for LGA 2011 sockets.
C. Spacer - Intel: Spacers used in conjunction with the backplate and screws for Intel LGA 2011 installations.
D. Screw - Intel: Standard screws for securing Intel mounting hardware.
E. Fixing Nut - Intel: Nuts used to fasten the Intel mounting brackets.
F. Bracket - Intel: Mounting brackets specifically designed for Intel CPU sockets.
G. Bracket - AMD: Mounting brackets specifically designed for AMD CPU sockets.
H. Screw - Intel/AMD: General-purpose screws applicable to both Intel and AMD installations.
I. Spacer - AMD: Spacers used for AMD installations.
J. Screw - Intel LGA 2011: Specific screws required for the Intel LGA 2011 mounting mechanism.
K. Thermal Grease: A thermal compound applied between the CPU and the heatsink to improve heat transfer.

Diagrams in this section visually identify each part and provide its name in multiple languages.

Chapter 2 - Intel Installation Guide

Follow these steps to install the JONSBO CR-1400 DV2 Series cooler on an Intel platform:

Step 1: Install Backplate

Attach the Intel backplate (B) to the motherboard and secure it using the Intel spacers (C).

Diagram shows the backplate (B) and spacers (C) being positioned and attached to the motherboard.

Step 2: Attach Mounting Brackets

Install the Intel mounting brackets (F) onto the backplate. Secure them using the fixing nuts (E) and screws (D).

Diagram illustrates the Intel brackets (F) being mounted onto the backplate, fastened with nuts (E) and screws (D).

Step 3: Apply Thermal Grease

Apply a small amount of thermal grease (K) evenly onto the center of the CPU's integrated heat spreader (IHS).

Diagram shows thermal grease (K) being applied to the CPU surface.

Step 4: Prepare Heatsink

If the fan is pre-attached, remove it from the heatsink assembly before mounting the heatsink onto the CPU.

Diagram shows the fan being detached from the main heatsink body.

Step 5: Mount Heatsink

Carefully place the heatsink onto the CPU, aligning the mounting mechanism with the installed brackets. Secure the heatsink according to the fastener design.

Diagram shows the heatsink being lowered onto the CPU and connected to the mounting brackets.

Step 6: Connect Fan and ARGB

Connect the CPU cooler's fan cable (CPU FAN) and the ARGB LED cable to the corresponding headers on the motherboard. Refer to the diagram for correct header locations.

Diagram shows the fan and ARGB cables being plugged into the motherboard headers.

Chapter 3 - AMD Installation Guide

Follow these steps to install the JONSBO CR-1400 DV2 Series cooler on an AMD platform:

Step 1: Remove Original AMD Bracket

Remove the stock AMD mounting bracket from the motherboard. It is recommended to keep the original backplane installed.

Diagram shows the removal of the original AMD mounting hardware.

Step 2: Install Backplane

Install the provided backplane onto the motherboard, ensuring it is correctly aligned.

Diagram illustrates the installation of the new backplane onto the motherboard.

Step 3: Install AMD Fasteners

Attach the AMD mounting brackets (G) and secure them using the appropriate screws (H).

Diagram shows the AMD brackets (G) being attached to the backplane, fastened with screws (H).

Step 4: Installation Preview

This diagram provides a visual representation of the completed cooler installation on the motherboard.

Diagram shows the final assembled state of the cooler mounted on the motherboard.

Step 5: Apply Thermal Grease