Perlesmith PSTVS07 Table Top TV Stand
Thank you for choosing Perlesmith. We strive to provide the best quality and services for our customers. Please share your experience on Amazon if satisfied. For any issues, please contact us.
Contact:
- Telephone: 800-5566-806 (Mon-Fri 10am - 6pm PST, USA/CAN)
- Email: supportus@perlesmith.com (US/CA/DE/UK/FR/IT/ES/JP/AU)
Component Checklist
- 1 Monitor Bracket (x1)
- 2 Plastic Cover (x1)
- 3 Support Pillar (x1)
- 4 Tempered Glass (x1)
Hardware:
- M4x15 (x4)
- M4x30 (x4)
- M6x15 (x4)
- M6x30 (x4)
- M8x15 (x4)
- M8x30 (x4)
- D5 washer (x4)
- D8 washer (x4)
- Rubber foot (x4)
- 5mm Allen key (x1)
- M8x25 (x3)
- D8 washer (x3)
- 5mm spacer (x4)
- 10mm spacer (x4)
- M8x45 (x1)
- Washer (x1)
Assembly Steps
STEP 1: Add Rubber Foot to Tempered Glass
Attach 4 rubber feet (C) to the tempered glass (4).
STEP 2: Connect the Support Pillar to Tempered Glass
Connect the support pillar (3) to the tempered glass (4) using M8x25 screws (E) and D8 washers (D).
STEP 3: Measure VESA and Check TV Screws
Measure the VESA hole pattern on the back of your TV. Ensure the measurements are within the compatible range (e.g., 75mm, 100mm, 200mm, 300mm, 400mm). To determine the correct screws, hand-thread screws into the TV's threaded inserts. Avoid over-tightening screws when attaching brackets to the TV.
Screw Check:
- Too Short: Indicates the screw is not long enough.
- Too Long: Indicates the screw is too long and may bottom out.
- Correct: Indicates the screw fits properly.
STEP 4: Attach the Monitor Bracket to a TV
Attach the monitor bracket (1) to the TV using the appropriate screws (M-A to M-F), washers (M-G, M-H), and spacers (M-I, M-J) if necessary. Ensure the monitor bracket is vertically centered.
STEP 5: Hang TV to Support Pillar
Hang the TV with the attached monitor bracket onto the support pillar using M8x45 screw (E) and washer (F).
STEP 6: Adjust Angle of TV Stand
Adjust the angle of the TV stand up to ±30°.
