Govee Quick Start Guide

Installation Steps:

1. Before installation, connect each string light and plug it into power to make sure every string light can work properly. Then disassemble the string lights.

   Diagram Description: Shows a string of lights connected in a series, with a power plug and a control box.

2. When installing this light during winter, it is advisable to install it within the warmer midday period. Applying heat to the adhesive backing with a hot water bottle or a hair dryer will help improve its adhesiveness in cold conditions.

   Diagram Description: Illustrates using a hot water bottle or hair dryer to warm the adhesive backing for better adhesion in cold conditions.

3. Prepare a stable ladder. Locate the power supply and the desired installation point for the first string light. Connect the first string light to the control box without connecting the power adapter, ensuring the control box cable is sufficiently long.

   A thermometer indicates 50°F (10°C).

   Diagram Description: Depicts preparing a stable ladder, locating the power supply, and choosing an installation spot. A thermometer indicates 50°F (10°C).

4. Clean the surface where you plan to install the string lights. It is recommended to vertically install the string lights 5-10 cm away from the wall surface. Make sure the surface is clean and dry.

   Diagram Description: Shows cleaning the installation surface and recommends a vertical installation 5-10 cm away from the wall surface, ensuring the surface is clean and dry.

5. Tear off the VHB tape and firmly press it against the surface for more than 5 seconds. Due to the length of the light string, press down on the previous light once more during installation.

   Diagram Description: Shows hands peeling off VHB tape and pressing it firmly against the surface for more than 5 seconds.

6. To ensure the string lights are firmly fixed on the eaves, it is recommended to use clips to keep the string lights secure.

   Diagram Description: Illustrates using clips to securely fix the string lights onto eaves.

7. Connect two string lights via the waterproof connectors. Firmly screw the waterproof connector cap. Repeat steps 5, 6, and 7.

   Diagram Description: Shows connecting two string lights using waterproof connectors and firmly screwing on the connector cap.

8. After connecting all string lights, firmly screw the waterproof connector cap of the last string light section.

   Diagram Description: Shows screwing the waterproof connector cap onto the last string light section after all lights are connected.

9. Plug into power and enjoy your lighting effects.

   Diagram Description: Shows plugging the lights into a power source to enjoy the lighting effects.