Oneisall ON-D80 Pet Grooming Vacuum System
Product Overview
The Oneisall ON-D80 is a pet grooming system designed to help keep pets clean and well-groomed while managing loose hair and debris.
Package Contents:
- Main Vacuum Machine x 1
- Storage Tray x 1
- Guide Combs x 6
- Hose x 1
- Crevice Tool x 1
- Cleaning Brush x 1
- Pet Paw Trimmer x 1
- Deshedding Brush x 1
- Grooming Brush x 1
- Electric Clipper x 1
- Pet Nail Grinder x 1
Product Technical Parameters
| Parameter | Specification |
|---|---|
| Input Power | UK: 220V-240V~50Hz / US: 110V~130V~60Hz |
| Motor Power | 300W |
| Hose Length | 1.5M |
| Dust Cup Capacity | 1.5L |
| Product Size | 302x220x130MM |
| Wire Length | 2.5M |
| Maximum Noise | 60dB |
Operation Instructions
1. Install the Dust Cup
- Align the snap-fit of the dust cup.
- Press the dust cup down by hand until it clicks into place.
Note: If the device has no suction or is very noisy, please reinstall the dust cup.
2. Ready to Use
- Connect the desired accessory to the vacuum cleaner through the hose.
- Insert the power plug into the socket.
- Turn on the switch to begin vacuuming.
Accessory and Power Mode Guide
The following guide provides advice on choosing accessories and power modes according to your needs.
General Functions and Power Modes:
- Silence Mode: Cleans fallen hair from the sofa, corner, or other hard-to-reach areas.
- Standard Mode: Cleans fallen hair from the sofa, corner, or other hard-to-reach areas.
- Max Mode: Deep cleaning of stubborn dust (A little noisy, but recommended).
Specific Accessory Functions and Recommendations:
-
Accessory: Electric Clipper (for trimming styling and hairstyle detail)
- Function: Trim and suck removed hair.
- Recommendation: Soft suction (Recommended).
-
Accessory: Vacuum for clothes
- Function: Deep clean hair on your clothes.
- Recommendation: Strong suction power (A little noisy, but recommended).
-
Accessory: Deshedding Brush / Grooming Brush (for de-shedding pet hair)
- Function: Remove loose hair.
- Recommendation: Soft suction to de-shed pet hair (A little noisy).
-
Accessory: Pet Paw Trimmer
- Function: Groom pet's paws, eyes, ears, face, and rump hair.
- Recommendation: Soft suction to trim and suck removed hair. (Avoid excessive force to prevent skin irritation).
-
Accessory: Pet Nail Grinder
- Function: Polish pet's nails by rounding them out.
- Recommendation: Soft suction to trim pet's nails. (Avoid excessive force to prevent skin irritation).
Safety Warnings and Use Precautions
- This product is for home use only, not for commercial or industrial use, nor for outdoor or humid places.
- Supervise use for children and people with physical and mental disabilities. Use in a safe environment under instruction and supervision. Never let a child use it unsupervised.
- Pay attention when using it near children and pets. Do not let children and pets play with this product.
- Do not touch the power plug and the product with wet hands.
- Do not use this product if the power cord or power plug is damaged.
- Do not use this product if it is not working normally or is damaged; contact the company.
- Do not disassemble the product; incorrect assembly may cause electric shock or fire. Contact the company if maintenance is needed.
- Do not inhale flammable or combustible liquids such as gasoline. Do not use in environments with flammable or combustible gases.
- Do not pull the power cord, place heavy objects on the machine, or pinch the cord.
- Do not use while smoking or working with other high-temperature items (matches, hot ash, etc.).
- Do not put things into the opening or block the opening.
- Please unplug the power cord when changing parts or conducting maintenance.
- Do not use or keep it outdoors or in other wet places.
- Do not use products with fragrance as they may contain flammable chemicals.
- Do not operate with wet hands or unplug the power cord to avoid failure and electric shock.
- Please do not smoke or use other flammable material.
- Please do not use the machine in or near an environment with flammable or combustible gases.
- There may be a strange smell during the first use; however, it will not cause adverse effects on the body.
- When using this product for the first time, it will smell, but it will disappear after a while. If the scorching smell persists, stop using it immediately.
- Please keep the dust cup and filter clean; dirty components may cause failure or accidents.
- During maintenance, turn off the power supply and unplug the power cord.
- If the power is on during maintenance, it can cause electric shock, accidents, or injury.
- The product will stop working when the temperature rises abnormally. If the motor overheats, stop using it immediately. If the suction opening is blocked, stop using it immediately. Take out the dust cup and clean the inlet and filter, then open it again after 60 minutes.
- Please be sure to install and use the filter; removing the filter will lead to failure.
Care and Maintenance
Cleaning the Dust Cup
- Press the remove button and take off the dust cup.
- Press the release button and pour out the hair.
- Assemble the dust cup according to the arrow direction.
Note: If the removed dust cup is cleaned with water or a wet cloth, ensure it is completely dry before reinstalling to prevent motor damage. Handle the dust cup gently as it can be easily damaged if dropped. For issues with the cup, contact support@oneisall.com.
Cleaning the Electric Clippers
- Remove the blade by turning it counterclockwise.
- Vacuum out and clean the debris from the blade and the clipper.
- Place oil on the blade. (Note: Oil is not included and must be purchased separately).
Cleaning the HEPA & Sponge Filter
- Remove the dust cup and then remove the HEPA & sponge filter.
- Tap it or clean it with a brush. Do not wash it with water.
- Place the HEPA & sponge filter back into the machine.
Troubleshooting
| Problem | Possible Causes | Solutions |
|---|---|---|
| Cannot be turned on | Plug not been inserted well Switch not been turned on |
Reinsert the plug Press switch button to turn it on |
| Weak suction | Flexible hose is clogged Dust cup is too full Filter is dirty |
Clean flexible hose and suction mouth Empty dust cup Clean filter |
| The Pet Clippers heats up during use | Internal parts of the machine have debris | Please remove the blade. Wash and oil |
| The hose is broken | Accidental damage Bitten by pets at home |
The hose is detachable and can be stored in the bag provided |
| Whistle-like noise when the machine is running | The Dust Cup snap is not aligned | Please check whether the Dust Cup is installed correctly |
If the above solutions do not solve the problem, please stop using the product and contact customer support: support@oneisall.com.
Contact Information and Warranty
Oneisall offers a standard 2-year warranty. For any issues with your Oneisall product, please contact support. Include proof of purchase, model number, and relevant photos or videos to expedite the process. Oneisall support is available 7 days a week and aims to respond within 24 hours.
Note: The Oneisall warranty does not apply to used products, purchases from unauthorized sellers, or consumable parts such as blades, guards, filters, and brushes.
Contact:
- Email: support@oneisall.com
- Phone: +1 877-522-8578 (US) Mon-Fri 8am-5pm (PST)
- Website: www.oneisall.com
For guide videos and more information, visit @Oneisall Official channels.
