Usage Instructions
- To turn on, press and hold the power button (1) for 2-3 seconds.
- Press the power button repeatedly to cycle through different light modes.
- Double-click the power button to activate strobe mode from any other mode.
- A single click will return the light to low mode.
- To turn off, press and hold the power button for 2-3 seconds.
[Diagram: Headlamp with a callout pointing to the power button labeled '1']
To Recharge
- Plug the supplied USB cord into a USB power source (minimum 500mA).
- Gently plug the other end into the covered charge port located on the back of the unit.
- A red LED ? will light up to indicate charging is in progress.
- A green LED ? indicates the Luna Fire RX is fully charged.
- The charge time is approximately 3 hours for a fully depleted battery.
- Once fully charged, unplug the Luna Fire™ RX from the USB power supply.
- Ensure the port cover gasket is returned to its original position.
- Store the charger cord until its next use.
Wearing Options
The Luna Fire™ RX can be worn in multiple ways:
- With included belt: The headlamp can be attached to the provided strap and worn around the waist or chest. [Diagram: Shows the headlamp attached to a strap worn around a person's torso.]
- Remove strap to clip anywhere: The strap can be removed, allowing the headlamp to be clipped directly onto clothing, a backpack strap, or other gear. [Diagram: Shows the headlamp detached from the strap and clipped onto a piece of fabric.]
Adjusting Angle
The headlamp's angle can be adjusted to direct light as needed. [Diagram: Series of images showing the headlamp unit tilting upwards and downwards relative to its base.]
Weather Resistance
? IPX4 Weather Resistant: This product is protected against splashing water from any direction.
- [Diagram: Headlamp with a checkmark ✔️, indicating it is protected against splashes.]
- [Diagram: Headlamp with a cross ❌ and water spray, indicating it is not protected against direct water jets.]
Cleaning and Drying
- Clean the headlamp using a soft, damp cloth. [Diagram: A soft cloth wiping the headlamp lens.]
- Allow the headlamp to air dry completely. [Diagram: Headlamp drying in the air.]
- Avoid using harsh chemicals or abrasive materials.
- Do not place the headlamp in a clothes dryer or expose it to high heat for drying. [Diagram: A clothes dryer with a cross ❌ through it.]
- Do not dry in direct sunlight. [Diagram: A sun symbol with a cross ❌ through it.]
Lamp Precautions
- ? Do not look directly at the light: The bright LED can cause temporary vision impairment. [Diagram: A person's eye with a red line through it, pointing towards a light source.]
- ? Do not attempt to disassemble: The unit contains no user-serviceable parts. Disassembly may damage the product and void the warranty. [Diagram: A screwdriver next to the headlamp with a red line through it.]
Disposal
- Please dispose of this product responsibly. ♻️ Recycle electronic waste according to local regulations. [Diagram: Recycling symbol.]
- If recycling is not possible, dispose of in a designated waste bin. ?️ Dispose of properly. [Diagram: Trash bin symbol.]