STRIMSÄV LED Spotlight
By IKEA
Product Overview
The STRIMSÄV is an LED spotlight designed by IKEA for indoor use, providing flexible lighting solutions for cabinets and shelves.
Important Safety Information
[!] WARNING – Strangulation hazard.
- NEVER place the cord within reach of children in a cot or playpen.
- ALWAYS secure the cord to a wall or cabinet.
- Check regularly that the cord is securely fastened.
- Pull the cord to remove any slack between fasteners. Tie up any remaining slack cord between the driver and socket.
[ℹ️] For indoor use only.
[ℹ️] The light source of this luminaire is not replaceable. When the light source reaches its end of life, the whole luminaire shall be replaced.
[ℹ️] ONLY USE A SAFETY TRANSFORMER WITH A SELV OUTPUT AS A SUPPLY FOR THE PRODUCT.
Package Contents
- 1x USB Power Adapter
- 1x Adhesive Ring
- 1x Cable Organizer
- 5x Adhesive Cable Clips (Half-circle)
- 5x Adhesive Cable Clips (Full-circle)
Assembly Instructions
Step 1: Prepare Mounting Surface
Identify the desired mounting location. If mounting inside a cabinet, drill an 8 mm (5/16") hole for the cable.
[ℹ️] Ensure the surface is clean and dry before applying adhesive components.
Step 2: Attach Adhesive Components
Peel the backing from the adhesive ring and attach it to the back of the light unit.
Peel the backing from the adhesive cable clips. Use the 5 half-circle clips and 5 full-circle clips to manage and secure the power cable along the desired path (e.g., inside a cabinet).
[ℹ️] Apply firm pressure to the adhesive clips for at least 5 seconds to ensure a secure bond.
Step 3: Mount the Light
Attach the light unit to the prepared mounting surface or clips.
[ℹ️] The light can be adjusted by gently pressing or sliding the unit.
Step 4: Connect Power
Connect the USB cable to the light unit.
Plug the USB power adapter into a wall socket.
Alternatively, connect the USB cable to a compatible device like a laptop.
Step 5: Operation
The light can be turned on/off and dimmed by touching the surface of the light unit.
[ℹ️] The light intensity can be adjusted by touching and holding the light.
Step 6: Maintenance and Removal
To clean the light, gently wipe the surface with a damp cloth. Avoid submerging the unit in water.
[ℹ️] To remove the light, gently detach it from its mounting clips.
[!] Be cautious when removing the light to avoid damaging the surface or the unit.
Notes
Diagram on page 4 shows a person confused with assembly, then calling IKEA for help.
The product reference number is AA-2414619-3.
