Honeywell HC30WB5R2 WDR 5 MP IR Bullet Camera

Installation Steps

1. Mounting Preparation: Mark drilling points based on the camera's mounting bracket. Drill holes with a ø30mm drill bit for cable entry and ø5mm holes for mounting screws. Ensure the mounting surface can support the camera's weight.

2. Cable Connections: Connect the power cable (12V DC Optional) and network cable (PoE). The camera can be powered via a 12V DC adapter or Power over Ethernet (PoE) compliant with IEEE 802.3af.

3. Camera Mounting: Secure the camera to the mounting surface using the provided screws (M4x25 and M2.5x8). Ensure the IP66 rating is maintained by properly sealing any openings.

4. Optional Mounts: For specific installations, optional support brackets like HBS2-BB or HQA-PM2 with HBS2-BB may be used. Refer to the diagrams for specific bracket installations.

5. Final Adjustments: Adjust the camera's position for optimal viewing angle. Ensure all connections are secure.

6. Power On and Configuration: Power on the camera. The default IP address is 192.168.1.108 if a DHCP server is unavailable. Use the Honeywell Config Tool to find the camera on the network.

Logging On to the Camera

The default username is 'admin' (case-sensitive) and the default password is '1234'. Internet Explorer 11 or later with ActiveX plug-in is supported. Chrome 71 or later is supported for H.264 video, but not for H.265 video.

Adjusting Zoom and Focus

After logging in, navigate to Camera Setup → Properties → Focus to adjust zoom and focus settings using the provided controls.

Important Safeguards

• Read and keep all instructions.
• Ensure the installation area can safely support the camera's weight.
• Avoid aiming the camera at bright light sources for extended periods to prevent imager damage.
• Do not touch the camera lens.
• Do not drop the camera or subject it to physical shock.
• Use a mild detergent for cleaning.
• Operate within the recommended temperature range of -22°F to 140°F (-30°C to 60°C).
• Avoid operating near strong electromagnetic radiation sources.
• If using a power adapter, ensure it is properly grounded and CSA Certified/UL Listed LPS or Class 2.

Cautions and Warnings

CAUTION: RISK OF ELECTRIC SHOCK. DO NOT OPEN. Refer servicing to qualified personnel. Ensure proper voltage is supplied.

WARNING: Indicates dangerous voltage. Indicates important operating and maintenance instructions.

Regulatory Statements

Manufacturer's Declaration of Conformance: This equipment complies with relevant European directives and standards for emissions, immunity, and electrical safety.

Waste Electrical and Electronic Equipment (WEEE): Dispose of this product according to local laws and regulations.

FCC Statement of Compliance: This equipment complies with FCC Rules Part 15 for Class B digital devices, designed to provide reasonable protection against harmful interference in a commercial environment. Modifications not expressly approved may void the user's authority to operate the equipment.