Samsung PL200 SD Card Replacement
Written By: Jacob Presnell
This guide for the Samsung PL200 is for replacing the SD card. It is a straightforward task and no problems should be encountered.
Introduction
Replace the SD card on your Samsung PL200 to provide more memory space as well as replacing a defective card. This is a simple replacement that requires no tools and can be completed in less than 2 minutes.
Step 1: Accessing the SD Card Slot
Image Description: The Samsung PL200 camera is shown from its underside. A finger is pressing a sliding release button labeled 'OPEN' on the camera's base.
Image Description: The battery/SD card compartment door on the bottom of the Samsung PL200 is open. An arrow indicates the direction to slide the release button to open the compartment.
- Flip the Samsung PL200 over to access the battery/SD card compartment on the bottom.
- Locate the sliding release button labeled 'OPEN' which can be slid sideways to open the battery/SD card compartment.
- Slide this button in the direction indicated by the arrow to release and open the spring-loaded battery/SD card compartment door.
[Important] Once the compartment is opened, the SD card should be visible.
Step 2: Removing the Old SD Card
Image Description: A finger is pressing down on the SD card within its slot in the Samsung PL200's compartment.
Image Description: The SD card has been partially ejected from the slot and is raised slightly, making it accessible for removal.
- Once the battery/SD card compartment is opened, simply push the SD card down to activate the spring-loaded ejector.
- This action will cause the SD card to raise up enough to allow you to grab it with your fingers.
- Use your fingers to remove the old SD card.
Step 3: Inserting the New SD Card
Image Description: A finger is inserting a new SD card into the SD card slot of the Samsung PL200.
Image Description: The new SD card is fully inserted into the Samsung PL200's slot and sits flush with the compartment.
- Insert the new SD card into the SD card slot.
- Make sure to push it down all the way until it clicks and remains flush with the battery compartment.
- Close the battery/SD card compartment.
To reassemble your device, follow these instructions in reverse order.
Document generated on 2017-06-27.
