atomi Bluetooth® Shower Speaker

Introduction

Thank you for purchasing the atomi Bluetooth® Shower Speaker! Make your shower a little more lively with this water-resistant speaker. Enjoy your groove or listen to the latest weather and traffic updates. Stream music via Bluetooth® technology for high-quality, great sounding audio.

Date Code: 01/21

Package Contents

• 1. 5W Shower speaker
• 2. Micro-USB cable
• 3. Suction cup
• 4. User guide

Controls

The speaker features a circular control panel with the following buttons:

• Play/Pause/Stop: Top button.
• Previous Song / Volume Down: Left button. Hold to decrease volume.
• Next Song / Volume Up: Right button. Hold to increase volume.
• Power On/Off / Answer/Hang up Call: Bottom button. Press to turn the unit on or off. Press to answer or end a call.
• Microphone: Located centrally for hands-free calls.
• Speakers: The audio output area.

Charging Indicator: A small LED indicates charging status:

• Not Charging: [Indicator Off/Red]
• Charging: [Indicator Blinking Red]
• Fully Charged: [Indicator Solid Blue/Green]

The unit also features a Micro-USB port for charging and a Suction cup for mounting.

Charging the Unit

Charge the speaker using the included USB to Micro-USB cord. Connect it to a computer or an AC adapter with a USB jack (adapter not included).

Note: Please allow approximately 2 hours for a full charge. The battery will last up to 6 hours when connected wirelessly.

Diagram Description: A USB to Micro-USB cable connects a power source (e.g., computer, AC adapter) to the speaker's Micro-USB port. The suction cup is shown attached to the speaker.

IPX4 Water Rating

The unit has a water resistance rating of IPX4. This rating is suitable for indoor and outdoor use in the presence of incidental or light exposure to splashing water, rain, or snow. Water splashing against the enclosure from any angle should have no harmful effects.

Important: Please do not submerge the speaker in water for any amount of time. Do not allow water to get into the speaker mesh side, as this will decrease the volume. Rotate the speaker to allow any accumulated water to exit.

IMPORTANT: To ensure your speaker is prepared for use in a wet environment, disconnect and remove any power cables, and tightly close the charging port water cap. If the water cap is not properly closed, water resistance will be compromised and could result in damage to the speaker or personal injury.

Icon Description: The IPX4 rating symbol, indicating resistance to splashes from any direction.

Pairing the atomi Shower Speaker

To listen to music over Bluetooth® wireless connection, pair your device with the atomi shower speaker:

1. Make sure your device has Bluetooth® capability.
2. Press and hold the power button for 5 seconds. You will hear a musical sound, indicating the speaker is on.
3. Follow the instructions on your device to pair the unit.
4. On your device's Bluetooth® listings, select "Shower Speaker" or select "YES" if prompted.
5. Press play on your device and use the speaker's controls to adjust the desired volume.

Note:

• Once successfully paired, you may not need to repeat these steps.
• For computer pairing, consult your computer manufacturer for specific instructions or drivers.
• Keep all non-water-resistant devices (phones, MP3 players, etc.) in a dry place, away from water.
• A pairing code is not required.
• The atomi Shower Speaker will automatically power off after 10 minutes of inactivity.
• For best suction, mount the speaker on a clean, dry surface. Lightly wetting the suction cup can help it adhere better.

Bluetooth Range: Up to 33ft (10m). Connectivity may be affected by walls and distance.

Built-in Speakerphone

The atomi Shower Speaker is equipped with a built-in speakerphone for easy hands-free talking:

1. Ensure the atomi Shower Speaker is successfully paired with your device.
2. To answer or end a call, simply press the call button (bottom button) when you hear a ringtone.

Note: When an incoming call is detected, the speaker will pause music and play a ringtone. Music will resume automatically after the call ends. When making a call, use your phone to dial; the speaker will automatically switch to hands-free mode.

Maintenance

Only use a soft, dry cloth to clean the enclosure. NEVER use liquids or abrasive cleaners.

Troubleshooting

If you experience connectivity issues, ensure your device is within Bluetooth range (33ft) and that there are no significant obstructions like thick walls. If the speaker does not power on, ensure it is charged. For pairing issues, try forgetting the device on your phone and re-pairing.

Important Safeguards & FCC Compliance

Important Safeguards:

• Read all instructions before use.
• WARNING: Do not place speakers too close to ears, especially for young children, as it may damage eardrums.
• Use this product only for its intended purpose as described in this manual.
• atomi is not liable for damage to smartphones, iPods®, MP3 players, or other devices.
• This product is not a toy and is not intended for use by children.
• Never operate this product if it has a damaged cord, plug, cable, or housing.
• Keep away from heated surfaces.
• Only set on dry surfaces. Do not place on surfaces wet from water or cleaning solvents.

FCC Warning:

This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) it must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC RF Exposure Statement: The device has been evaluated to meet general RF exposure requirements and can be used in portable exposure conditions without restriction.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.