Atomi Bluetooth® Shower Speaker User Guide

Introduction

Thank you for purchasing the atomi Bluetooth® Shower Speaker! Make your shower a little more lively with the atomi Shower Speaker! Get your groove on or listen to the latest weather and traffic before you start your day. Just hang the water-resistant speaker in your shower and stream music through it via Bluetooth® technology. High quality, great sounding, your shower will be rockin' with the atomi Shower Speaker!

Date Code: 01/21

Package Contents

• 1. 5W Shower speaker
• 2. Micro-USB cable
• 3. Suction cup
• 4. User guide

Controls

The speaker features the following controls and indicators:

• Power/Play/Pause/Stop: Press and hold for 5 seconds to turn the unit on or off. Press once to play or pause music. Double press to stop music.
• Volume Down / Previous Song: Press to decrease volume. Press and hold to go to the previous song.
• Volume Up / Next Song: Press to increase volume. Press and hold to go to the next song.
• Microphone: Built-in microphone for hands-free calls.
• Speakers: Audio output.
• Micro-USB port: For charging the unit.
• Suction cup: For mounting the speaker.

Charging the Unit

Charge the speaker using the included USB to Micro USB cord. Connect it to a computer or an AC adapter with a USB jack (adapter not included).

Note: Please allow approximately 2 hours for a full charge. The battery will last up to 6 hours when connected wirelessly.

IPX4 Water Rating

This unit has a water resistance rating of IPX4, meaning it is splash resistant from any direction. This rating is suitable for indoor and outdoor use in the presence of incidental or light exposure to splashing water, rain, or snow. Water splashing against the enclosure from any angle should have no harmful effects.

Important: Do not submerge the speaker in water for any amount of time. Avoid getting water into the speaker mesh side, as this will decrease the volume. Rotate the speaker to allow any accumulated water to exit.

IMPORTANT: To ensure your speaker is prepared for use in a wet environment, disconnect and remove any power cables, and tightly close the charging port water cap. If the water cap is not properly closed, water resistance will be compromised and could result in damage to the speaker or personal injury.

Troubleshooting & Pairing

Pairing the atomi shower speaker:

1. Ensure your device has Bluetooth® capability.
2. Press and hold the power button for 5 seconds. You will hear a musical sound, indicating the speaker is on and ready to pair.
3. Follow your device's instructions to pair the unit.
4. On your device's Bluetooth® listings, select "Shower Speaker" or select "YES" to pair.
5. Press play on your device and use the controls on the speaker to adjust the volume.

Bluetooth Range: The Bluetooth range is up to 33 feet (10 meters). Connectivity interference can be caused by walls and distance.

Notes:

• Once successfully paired, you may not need to repeat the pairing steps.
• When pairing with a computer, consult your computer manufacturer for Bluetooth® pairing instructions and/or the latest Bluetooth® drivers.
• Keep all non-water-resistant devices (phones, MP3 players, etc.) in a dry place away from water.
• A pairing code is not required.
• The atomi Shower Speaker will automatically power off after 10 minutes of inactivity.
• For best suction results, mount the shower speaker on a clean and dry surface. Adding a little water to the suction cup can help it retain rigidity.

Built-in Speakerphone

The atomi Shower Speaker is equipped with a built-in speakerphone for easy hands-free talking:

1. Ensure the atomi Shower Speaker is successfully paired with your device.
2. To answer or end a call, simply press the call button (Power/Play/Pause/Stop button) when you hear a ringtone.

Note: When an incoming call is detected, the atomi Shower Speaker will pause the music and play a ringtone. After the call ends, the music will resume automatically. When making a call, use your phone to dial, and the atomi Shower Speaker will automatically switch to hands-free mode.

Maintenance

Only use a soft dry cloth to clean the enclosure of the unit. NEVER use liquids or abrasive cleaners.

FCC Warning & Important Safeguards

FCC Compliance: This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operations.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: reorient or relocate the receiving antenna, increase the separation between the equipment and receiver, connect the equipment into an outlet on a circuit different from that to which the receiver is connected, or consult the dealer or an experienced radio/TV technician.

Important Safeguards:

• Read all instructions before using.
• WARNING: Do not place speakers too close to ears. May cause damage to ear drums, especially in young children.
• Use this product only for its intended use as described in this manual.
• Atomi is not liable for any damage caused to smartphones, iPod®/MP3 players, or any other device.
• Not for use by children. THIS IS NOT A TOY.
• Never operate this product if it has a damaged cord, plug, cable, or housing.
• Keep away from heated surfaces.
• Only set on dry surfaces. Do not place on surfaces wet from water or cleaning solvents.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device.