Aosu Product Compliance and Customer Service

Notice

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/ TV technician for help.

FCC Radio Frequency Exposure Statement

The device has been evaluated to meet general RF exposure requirements. The device can be used in fixed/mobile exposure condition. The min separation distance is 20cm.

IC Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

In French: L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) L'appareil ne doit pas produire de brouillage; (2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

IC RF Statement

This equipment complies with IC RSS - 102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

In French: Cet équipement est conforme aux limites d'exposition aux radiations IC CNR - 102 établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.

CE Declaration and Environmental Information

[CE Mark] This product complies with the radio interference requirements of the European Community.

Declaration of Conformity

Hereby, aosu declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of conformity, visit the Web site: https://www.aosulife.com.

This product can be used across EU member states. Do not use the Device in the environment at too high or too low temperature, never expose the Device under strong sunshine or too wet environment. The suitable temperature for Camera and accessories is -10°C–50°C.

RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between the device and the human body. To maintain compliance with RF exposure requirement, use product that maintain a 20cm distance between the device and human body.

[Recycling Symbol] This product is designed and manufactured with high quality materials and components, which can be recycled and reused. This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.

Customer Service

Warranty

12-month limited warranty (The actual warranty period shall be implemented according to the requirements of local laws and regulations).

Email Us

Customer Support: support@zoohilife.com

Call Us

United States: +1-866-905-9950 Mon-Fri 9AM-5PM (PST)
United Kingdom: +44-20-3885-0830 Mon-Fri 9AM-5PM (GMT)
Germany: +49-32-221094692 Mon-Fri 9AM-5PM (CET)
Japan: +81-50-5840-2601 Mon-Fri 9AM-5PM (JST)

Connect with Us

Facebook: @aosulife
Twitter: @aosulife
YouTube: @aosulife

	Shenzhen Zhiling Technology Co., Ltd. Declaration of Difference for AOSU OutdoorCam D1 Lite Declaration of difference statement from Shenzhen Zhiling Technology Co., Ltd. for the AOSU OutdoorCam D1 Lite product line, confirming shared internal components across models C5L, C5E, C5P, C5S, DC5L, DC5E, DC5P, DC5S. Includes FCC ID 2A2VW-C5L.
	Shenzhen Zhiling Technology Co., Ltd Declaration: SolarCam P1 Lite Models C8L, C8E, C8P, C8S, DC8L, DC8E, DC8P, DC8S Declaration from Shenzhen Zhiling Technology Co., Ltd regarding model differences for the SolarCam P1 Lite series, including models C8L, C8E, C8P, C8S, DC8L, DC8E, DC8P, DC8S, and FCC ID 2A2VW-C8L.
	AOSU SolarCam D1 Classic: Quick Start Guide for Solar-Powered Wireless Security Camera Get started quickly with the AOSU SolarCam D1 Classic, a solar-powered wireless security camera. This guide covers what's included, product overview, setup, mounting, and installation tips for optimal performance.
	AOSU SolarCam D1 Lite Quick Start Guide A quick start guide for the AOSU SolarCam D1 Lite, a solar-powered wireless security camera. This guide covers what's included, product overview, system setup, camera mounting, important notices, and customer service information.
	AOSU WirelessCam Pro FCC & IC Certification Labeling Details Official FCC and IC certification labeling information for the AOSU WirelessCam Pro, including model C6P2AH11, FCC ID 2A2VW-C6P, and IC 28138-C6P. Details label location and dimensions.
	AOSU WirelessCam Max FCC ID 2A2VW-C6S Label and Location Information This document provides the label and location details for the AOSU WirelessCam Max, model C6S2AH11, with FCC ID 2A2VW-C6S and IC: 28138-C6S. It includes a visual representation of the label placement on the device.
	AOSU 2K Wi-Fi Security Camera (P1 Lite) - Quick Start Guide Get started with your AOSU 2K Wi-Fi Security Camera (P1 Lite). This guide covers setup, installation, product overview, and customer support for your AOSU security device.
	AOSU WirelessCam Pro Agent Authorization - Shenzhen Zhiling Technology Co., Ltd Agent authorization from Shenzhen Zhiling Technology Co., Ltd for MiCOM Labs Inc. concerning the certification of the AOSU WirelessCam Pro, model numbers C6P2AH11 through C6P3AH18, FCC ID 2A2VW-C6P.