Videx VLF-H147 LED Rechargeable Headlamp
User's Manual
1. Specifications
Feature | Specification |
---|---|
Model | H147 |
Luminous Flux | TURBO*: 700Lm, HIGH: 550Lm, MIDDLE: 200Lm, LOW: 70Lm, COB HIGH: 200Lm, COB LOW: 50Lm, RED HIGH: 20Lm, RED LOW: 5Lm, RED FLASH: 8Lm |
Runtime | TURBO*: 2h, HIGH: 4h, MIDDLE: 5h, LOW: 30min, COB HIGH: 13h 30min, COB LOW: 4h, RED HIGH: 10h 30min, RED LOW: 4h, RED FLASH: 18h 30min |
Beam Distance | TURBO*: 185m, HIGH: 185m, MIDDLE: 120m, LOW: 65m, COB HIGH: 20m, COB LOW: 10m, RED HIGH: 5m, RED LOW: 3m, RED FLASH: 3.5m |
Light Intensity | TURBO*: 11600cd, HIGH: 8800cd, MIDDLE: 3840cd, LOW: 1040cd, COB HIGH: 104cd, COB LOW: 32cd, RED HIGH: 4.8cd, RED LOW: 1.36cd, RED FLASH: 2.2cd |
LEDs Type | CREE XPG3 + 3W COB |
Light Color Temperature | 5000 K |
Viewing Angle | 155˚, 80˚, 155˚ |
Battery Type | Li-pol 1800mAh, 3.7V (built-in) |
Input Parameters | USB-C 5V 0.8A |
Charging Time | 3h 30min |
Dust and Moisture Protection Level | IP55 |
Impact Resistance Level | 1 m |
Product Dimensions | 80 x 49 x 45 mm |
Product Weight | 135 g |
Note: The output is measured based on the total runtime, including periods when the output is reduced due to overheat protection in the design. The actual performance of this product may vary depending on different working environments.
2. Product Overview
- 2.1 Rotary Switch
- 2.2 Push button
- 2.3 High beam LED
- 2.4 Low beam LED
- 2.5 Charging port
- 2.6 Battery indicator
3. Operating Instructions
- Turn the rotary switch to turn on and switch between different lighting modes.
- Red Light: Push and hold the button for 0.5 seconds to turn on or off the red light. With the red light switched on, single click the button to cycle between the red lighting modes.
- Adjust the headlamp tilt angle by rotating it up or down.
Note: The headlamp automatically memorizes the last red lighting mode and will apply it next time upon turning on.
4. Charging
- Turn off the headlamp and open the protective cover.
- Connect the USB-A end of the charging cable to a wall charger and the other end to the input port of the headlamp.
- During charging, the indicator divisions will flash from bottom to top displaying charging status. When the battery is fully charged, all divisions will light up together.
- After charging is complete, unplug the charging cable and close the protective cover to prevent water and dust from entering the headlamp body.
Recommendation: Recharge the stored headlamp every four months to maintain the Li-Pol battery normal performance.
5. Battery Indication
- With the light switched off, press the button once for the LED indicator to show the remaining battery level; the indication will last for 3 seconds. The indication is also displayed together with the light turned on.
- Each lit LED division indicates around 20% of energy remaining. All five lit divisions indicate that the battery is fully charged.
6. Maintenance
The rechargeable battery inside the headlamp is non-replaceable. Disassembling the sealed body may compromise the headlamp performance and will void the warranty.
Recharge the stored headlamp every four months to maintain the Li-Pol battery normal performance.
7. Warnings
- High-intensity light of the headlamp can cause eye damage. Avoid shining it directly into anyone’s eyes.
- Keep this headlamp out of reach of children.
- This headlamp generates considerable heat during operation, causing the shell to become hot. Use with caution to avoid burns.
- The LED inside this headlamp is non-replaceable. When the LED reaches the end of its service life, the entire headlamp should be replaced.
The manufacturer shall not be responsible for any damage resulting from the failure to follow these instructions. The manufacturer reserves the right to make changes to the manual - the current version can be downloaded from the website by scanning the QR code.
8. Warranty
The warranty for the headlamp is 2 years. The warranty does not cover accessories. During the warranty period, a faulty headlamp can be exchanged or returned with proof of purchase and all accessories saved. The following does not apply within the scope of limited warranty: Misuse the product and cause the product's integral components damage; Unauthorized disassemble or the presence of deep mechanical damage to the product; Damage due to force majeure.
9. The Box Contents
- 9.1 Headlamp
- 9.2 Headband
- 9.3 Charging cable USB-A to USB-C
- 9.4 User’s manual
- 9.5 Warranty card
Compliance Information
The product meets the requirements of EU directives and technical regulations of Ukraine.
Environmental Protection: It is forbidden to dispose of the product together with general waste. A used or damaged product should be disposed of in accordance with the Directive on Waste Electrical and Electronic Equipment (WEEE). Contact your local recycling organization for more details.
Manufacturer and Importer Information
Manufacturer: Allegro-opt PE, 106-ZH Heroiv Mariupolia, Kropyvnytskyi, 25004, Ukraine. Made in China.
Importer/Distributor Information varies by region:
- Poland: Allegro Opt Sp. z o.o., ul. Mierzeja Wiślana 11, 30-732 Krakow, Polska.
- Greece: Gigawatt EE, Parnithos 274, Acharnai, 13675, Greece.
- Hungary: Trog Kft., 6724 Szeged, Kenyérgyári út 15.
Production date and batch number are indicated on individual packaging.
Product materials: aluminum, tempered glass.
Shelf life before first use: 5 years.
The product complies with the following standards: DSTU EN IEC 55015:2021, DSTU EN 61547:2016, DSTU EN IEC 61000-3-2:2019, DSTU EN 61000-3-3:2017, DSTU EN 62321:2014, DSTU EN 50581:2014.
Visit us at: www.videx.ua or www.videx.com.pl