Lumascape FAISCA F3 LS9230 Installation and Safety Instructions

General Safety Warnings

WARNING – Product Warranty is void if product is not installed as per installation instructions and in compliance with all local and provincial codes.

Please read and follow all safety instructions carefully. Failure to do so will void warranty.

• Ensure installation complies with local electrical rules and regulations.
• All electrical work must be performed by a licensed electrician.
• Class III product SELV (symbol 3).
• For LED Options 2,700K, 3,000K, Red, Green, Blue, RGBA, RGBW, Tunable White: This product contains a light source of energy efficiency class G.
• For LED Options 3,500K, 4,000K, 5,000K: This product contains a light source of energy efficiency class F.
• All luminaires may become hot. Use discretion on where the luminaire is mounted. Take care when setting luminaire as it may become hot.
• Luminaire should only be used complete with protective shield. If protective shield is cracked, immediately stop using luminaire. Isolate light source, keep it dry and immediately contact Lumascape for replacement of protective shield (symbol 10).
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by Lumascape or their service agent in order to avoid a hazard.
• The light source contained in this luminaire shall only be replaced by Lumascape or their service agent.
• To reduce the risk of strangulation, the flexible wiring connected to this luminaire shall be effectively fixed to the wall if the wiring is within arm’s reach.
• Ensure mains input power is surge protected.
• Never make or break connections while the circuit is energized.
• Do not make modifications or alter the product.
• Keep luminaire clean and free of debris.
• Only clean with warm water.
• Do not use chemicals or abrasives to clean luminaire as this may void the product warranty.
• Connections are to be kept clean and dry at all times.
• Suitable for use indoors or outdoors.

Safety Symbols:

• Symbol 3: SELV (Safety Extra Low Voltage)
• Symbol 10: Contact Lumascape for replacement protective shield
• CAUTION Risk of Electric Shock
• Keep Away from Flammable Materials
• Do Not Use Silicone On Outside Surface
• Do Not Hose or Pressure Clean
• Keep Electronics Free From Dirt and Moisture
• Do Not Cut Cable to the Luminaire
• Do Not Use Power Tools on Screws
• Do Not Lift or Carry By the Cord

Assembly Instructions

Adjustable Mounting

1. Attach bracket to luminaire using M4 or #8UNC screws.
2. Secure luminaire to mounting surface.

Catenary Mounting

1. Attach bracket to luminaire using M4 or #8UNC screws.
2. Secure luminaire to catenary wire or cable.

Surface Mounting

1. Attach bracket to luminaire using M4 or #8UNC screws.
2. Secure luminaire to mounting surface.

Strap Mounting

1. Attach bracket to luminaire using M4 or #8UNC screws.
2. Secure luminaire using strap.

Screw Mount (Side and Bottom Entry)

Note: No mounting bracket is supplied. 4 x M4 screw points are provided for attaching to custom mounting plates and hardware.

Suitable for use on custom brackets.

Wiring Designations

PowerSync (6-Core)

Important Note: Do not Hi-Pot test.

Mounting and Dimensions

Various mounting types are supported including Adjustable, Catenary, Surface, Strap, and Screw Mount.

Refer to diagrams for specific dimensions and mounting details for each type.

Dimensions:

• Type S: Surface Mount (Side Entry Only)
• Type A: Adjustable Bracket (Side Entry Only)
• Type C: Catenary Mount (Side Entry Only)
• Type D: Screw Mount (Side and Bottom Entry)
• Type F: Strap Mount (Side Entry Only)

Product Resources

Find more product resources at lumascape.com.