MORRIS Espresso / Drip Coffee Maker

IMPORTANT SAFEGUARDS

1. Before using check that the voltage power corresponds to the one shown on the appliance nameplate.
2. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
3. To protect against fire, electric shock and injury to persons do not immerse cord, plug, or in water or other liquid.
4. Close supervision is necessary when any appliance is used by or near children.
5. Unplug from the outlet when not in use and before cleaning. Allow to cooling before putting on or taking off parts, and before cleaning the appliance.
6. The use of accessory not recommended by the appliance manufacturer may result in fire, electric shock or injury to persons.
7. Do not use outdoors.
8. Do not let the cord hang over the edge of a table or counter, or to touch any hot surface.
9. Do not place on or near a hot gas or electric burner, or in a heated oven.
10. Do not use the appliance for other than the intended use.
11. Do not set a hot container on a hot or cold surface.
12. Do not let the coffee machine operate without water.
13. The carafe is designed for use with this appliance. It must never be used on a range top.
14. Do not clean the carafe with cleansers, steel wool pads, or other abrasive material.
15. To disconnect, turn any control to “OFF”, remove the plug from the wall outlet. Always hold the plug. But never pull the cord.
16. Scalding may occur if the top lid is opened during the brewing cycles. Be careful not to get burned by the steam.
17. Some parts of the appliance are hot during operation, so do not touch with hand. Use handles or knobs only.
18. Never leave the empty carafe on the warming plate otherwise the carafe is liable to crack.
19. Never use the appliance if the carafe shows any signs of cracks or if it has a loose or weakened handle. Only use the carafe with this appliance. Use carefully as the carafe is very fragile.
20. Never place the carafe on a hot surface.
21. The appliance must not be immersed in water or any other liquid.
22. This appliance can be used by children aged from 8 years and above if they have been given supervision or instruction concerning use of the appliance in safe way and if they understand the hazards involved. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of reach of children aged less than 8 years.
23. Children shall not play with the appliance.
24. Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and they understand the hazards involved.
25. This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops, offices and other working environments; farm houses;
26. Save these instructions.

KNOW YOUR COFFEE MAKER

Diagram Description: The coffee maker features a top lid, a tank lid, and an espresso water tank. Below these are controls including a knob, a two-cup filter, a one-cup filter, a steam tube, and a pressurized portafilter. The main body houses the control panel and a drip tray. A glass carafe sits on a warming plate. A cleaning needle is also provided.

CONTROL PANEL

The control panel includes several buttons and indicators:

• POWER button and its indicator.
• STEAM PREHEAT button and its indicator.
• [single cup] button and its indicator for single coffee.
• [double cup] button and its indicator for double coffee.
• MINUTE button and its indicator.
• HOUR button and its indicator.
• PROGRAM button and its indicator.
• BREW-OFF button and its indicator.

LCD display

• Clock: Displays the current time.
• Coffee strength setting: Indicators for Light ([single bean]), Medium ([two beans]), Strong ([three beans]), and Extra-strong ([four beans]).
• CLEAN: Indicates that the appliance needs to be cleaned.
• PROGRAM: Indicates the auto-on time setting.

BEFORE FIRST USE

Check that all accessories are complete and the unit is not damaged. Clean all detachable parts well and understand all the parts and their functions. Add water into water tanks to the max level and brew water for several times without coffee powder, then discard the water.

OPERATION

The appliance has two brewing systems: “Drip coffee-brewing system” and “Espresso-brewing system”.

MAKE DRIP COFFEE

1. Open the drip coffee water tank lid and add drinking water into the drip coffee water tank. Note: Do not fill the water tank with water exceeding the max level. The appliance can brew up to 10 cups of coffee per cycle.
2. Place the filter into the coffee funnel and then place the coffee funnel into the funnel holder. Ensure the coffee funnel is well installed.
3. Add proper coffee powder into the filter. Typically, one level spoon of coffee powder per cup is recommended, adjustable to personal taste. For 10 cups of water, use 60g of coffee powder. Close the top lid.
4. Insert the glass carafe with its lid onto the warming plate horizontally, aligning the center line of the carafe with the anti-drip valve.
5. Connect the appliance to a power source (220V-240V/50-60Hz). All icons will appear on the LCD display, and all LED indicators will turn on for 2 seconds with a beep. The "Strength with one bean" indicator will light solidly. The "Clock", "PM", and "Time" will flash for 5 seconds, allowing time adjustment using the "HOUR" and "MINUTE" buttons. After setting the time, the appliance returns to standby mode, showing the time (AM/PM) and the "Strength with one bean" indicator.
6. Press the “BREW-OFF” button to start brewing coffee. Warning: Do not open the top lid during operation to avoid burns. Note: Only the “BREW-OFF” button functions during brewing.
7. Coffee dispenses from the outlet into the carafe. After brewing, the appliance enters keep-warm mode, displaying "TIME SINCE BREW" on the LCD, and the white background turns off. Note: The carafe can be removed for serving at any time; dripping stops automatically but for no more than 30 seconds.
8. After brewing, the appliance will sound 3 beeps to indicate keep-warm mode.

Setting Times and Strength

• Standby Time (Auto-on): Hold and press "HOUR" or "MINUTE" for 3 seconds. "Time", "AM/PM", and "Clock" flash while "Strength with one bean" is solid. Use "HOUR" and "MINUTE" to set the standby time. Confirm by pressing "PROGRAM" or letting it flash for 5 seconds.
• Auto-on Time: Press "PROGRAM". Its indicator turns on. "Program", "PM/AM" icons show, and the auto-on time flashes. "Strength with one bean" is solid. Use "HOUR" and "MINUTE" to set the auto-on time. Press "PROGRAM" to confirm and enter auto-on mode. If not confirmed, it flashes for 5 seconds and returns to standby. Press "PROGRAM" again to cancel. Note: After auto-on time starts, press "Power" to enter Espresso mode.
• Coffee Strength: Hold and press "PROGRAM" for 3 seconds. LCD shows time, "PM/AM", and "Strength with one bean" flashes. Press "PROGRAM" to cycle through strength settings ([single bean], [two beans], [three beans], [four beans] in sequence). The selected strength flashes for 5 seconds for confirmation before returning to standby.
• Auto-off Time (Keep-warm): Hold and press "BREW-OFF" for 3 seconds. Coffee strength shows on LCD, and auto-off time flashes. Use "HOUR" and "MINUTE" to adjust keep-warm time (0-4 hours). "HOUR" increments by 1 hour, "MINUTE" by 15 minutes. Confirm by letting it flash for 5 seconds or pressing "PROGRAM".

Notes:

• You can exit setting modes and enter brewing modes directly by pressing "Power" or "BREW-OFF".
• The Espresso-brewing system can operate while the Drip coffee-brewing system is working.
• The Espresso-brewing system can operate during the keep-warm stage; both heaters can be active simultaneously.

Espresso and Steam Functions

Always turn the appliance off and disconnect the power supply when not in use. Pay attention while serving coffee, as it is hot.

MAKE ESPRESSO

1. Open the Espresso water tank lid and add drinking water. Note: Do not exceed the max level.
2. Select the one-cup or two-cup filter, install it into the pressurized portafilter, and add coffee powder (7g for one cup, 14g for two cups). Tamp the powder with the coffee spoon and attach the portafilter.
3. Place a container/cup on the drip tray.
4. Connect to power. LCD and indicators show status, similar to drip coffee setup.
5. Press "Power" to start the Espresso system. "POWER" and "STEAM/PREHEAT" indicators light solidly; "One cup" and "Two cup" indicators flash, entering preheating mode. All Espresso indicators light solidly when preheating is complete. Hold "STEAM/PREHEAT" and a cup button until water flows out to prepare for brewing.
6. Press the "One cup" or "Two cup" button. "POWER" indicator stays on, the selected cup button flashes, and brewing begins. The appliance returns to standby after brewing. Only the selected button and "POWER" button work during brewing.
7. A red buoy indicates a full drip tray; empty it promptly.
8. Always turn off and disconnect power when not in use. Note: Drip coffee system can operate during Espresso brewing.

MAKE STEAM

1. Open the Espresso water tank lid and add drinking water. Note: Do not exceed the max level.
2. Connect to power. LCD and indicators show status, similar to drip coffee setup.
3. Press "Power". "POWER" and "STEAM/PREHEAT" indicators light solidly; "One cup" and "Two cup" indicators flash, entering preheating mode. Espresso indicators light solidly upon completion.
4. Press "STEAM/PREHEAT". "POWER" indicator illuminates, "STEAM/PREHEAT" flashes as the heater preheats. "STEAM/PREHEAT" indicator lights solidly when finished. Note: During standby for steam, "POWER" and "STEAM/PREHEAT" are solid. Pressing "STEAM/PREHEAT" again exits steam function; cup indicators flash for cooling. Pressing "POWER" turns off the appliance.
5. Rotate the knob to "Steam" position to activate steam. Turning the knob off stops the function. "STEAM/PREHEAT" illuminates; pressing it again exits steam mode. Cup indicators flash for cooling. Note 1: Release steam for 10 seconds for better milk frothing. Note 2: Steam function requires water flow after holding "STEAM/PREHEAT" and a cup button. Note 3: Preheating works if the knob is already at "Steam" before pressing "Power". Warning: Turn knob to off position after steaming to prevent scalding.

STANDBY MODE AND TROUBLESHOOTING

The LCD display background turns off after 15 seconds of inactivity in standby mode. The appliance enters sleep mode after 30 minutes of inactivity.

TO TURN OFF OR TURN ON THE BEEP SOUND

To turn off beeps: Simultaneously hold "PROGRAM" and "MINUTE" for 3 seconds; the [beep on icon] appears on the LCD. To turn on beeps: Repeat the process; the [beep off icon] disappears.

NTC MALFUNCTION

• For Drip coffee system: "MINUTE", "HOUR", "PROGRAM", and "BREW-OFF" indicators flash if the NTC is abnormal (open/short circuit).
• For Espresso system: "POWER" button, "One cup", "Two cup", and "STEAM/PREHEAT" indicators flash if the NTC is abnormal.

CLEANING AND MAINTENANCE

CAUTION: Unplug the appliance and let it cool completely before cleaning. Do not immerse the cord, plug, or unit in water or liquid to prevent electric shock.

1. Clean the lid, filter, water tank, and funnel with a damp cloth.
2. Clean the one-cup filter, two-cup filter, and steam tube with the cleaning needle if necessary.
3. Push the anti-drip valve upwards 3-4 times to empty residual water.
4. Wipe the external surface with a soft, damp cloth to remove stains.
5. Wipe off any water droplets above the coffee funnel that may drip onto the base during brewing with a clean, dry cloth after each use.
6. Wipe the warming plate with a damp cloth; do not use abrasive cleaning agents.
7. When the appliance has performed 300 drip coffee brewing cycles, the LCD will show "CLEAN" flashing. To clean, simultaneously hold "HOUR" and "MINUTE" for 3 seconds to enter cleaning mode. "CLEAN" is shown, and a beep sounds. Press "BREW-OFF"; its indicator lights up, and the appliance runs until the water tank is empty, followed by a beep. The appliance returns to standby after cleaning. You can press other buttons to continue normal operation if you don't want to clean.
8. Replace all parts and keep them for future use.

REMOVING MINERAL DEPOSITS

To maintain efficiency, periodically clean mineral deposits. Recommended procedure:

1. Fill the tank with water and descaler to the max level (water:descaler ratio 4:1, or use citric acid: 100 parts water to 3 parts citric acid).
2. Insert the glass carafe onto the warming plate.
3. Ensure the filter and funnel are in place; do not add coffee powder.
4. Switch on the appliance and allow it to "brew" the de-scaling solution.
5. After brewing one cup of solution, switch off the appliance.
6. Let the solution sit for 15 minutes, then repeat steps 4-6.
7. Switch on the appliance and run off the remaining solution until the water tank is empty.
8. Rinse by operating the appliance with clean water at least 3 times.

HINTS FOR GREAT-TASTING COFFEE

• Regularly clean the coffee maker as specified in the "CLEANING AND MAINTENANCE" section. Always use fresh, cold water.
• Store unused coffee powder in a cool, dry place. Reseal opened packages tightly and store in the refrigerator for freshness.
• For optimal taste, use whole coffee beans and grind them just before brewing.
• Do not reuse coffee powder; it reduces flavor. Reheating coffee is not recommended as peak flavor is immediately after brewing.
• Clean the coffee maker if over-extraction causes oiliness. Small oil droplets in brewed coffee are from coffee powder extraction.
• Oiliness may occur more frequently with heavily roasted coffee.

SPECIFICATIONS

NOTICE ABOUT RECYCLING

Your product is designed and manufactured with high quality materials that can be recycled and reused. The symbol [recycling symbol] means that electrical and electronic equipment, at their end-of-life, should be disposed of separately from household waste. Please dispose of this equipment at your local community waste collection/recycling center. In the European Union, there are separate collection systems for used electrical and electronic products. Please help us conserve the environment.

DECLARATION OF CONFORMITY

Herewith, Amiridis-Savvidis S.A. states that this product complies with the requirements of the following directives:

• EMC-Directive: 14 / 30 / EU
• Low Voltage Directive: 14 / 35 / EU
• ErP Directive 09 / 125 / EC
• CE Marking: 93 / 68 / EEC
• RoHS Directive: 11 / 65 / EU & 15 / 863 / EU

The detailed declaration of conformity can be found at www.morris.gr.

Exclusive importer in Greece:

Amiridis - Savvidis S.A.
87A, 17th Noemvriou str, P.C. 55534
Thessaloniki - Greece
T: +302310944944 | F: +302310944940
www.amiridis-savvidis.gr