VIQUA VH150, VH200, VH410, VH410M Ultraviolet Water Disinfection Systems

Introduction

The quality of drinking water can change over time and become contaminated with harmful bacteria. The VIQUA HOME family of compact UV disinfection systems offers a reliable, economical, and chemical-free method to safeguard drinking water in any residential application. VIQUA products are designed and tested to ensure quality drinking water is readily available.

VIQUA systems are available to suit various requirements, with flow rates ranging from 5 GPM for small homes or cottages up to 18 GPM for larger homes or small businesses.

Typical Installation Diagram

A diagram illustrates a typical water installation setup for a VIQUA UV system. It shows the main water line flowing through a water meter, an optional water softener, an optional bypass assembly, a 5-micron sediment filter, an optional carbon filter, and then into the VIQUA UV system chamber. The system includes shut-off valves before and after the filters and UV chamber. An optional temperature management valve and solenoid valve are also shown, along with a customer-supplied GFI circuit to match voltage. Connections for hot and cold water pipes are indicated.

Features of VIQUA UV Water Disinfection Systems

Equipped to inactivate chlorine-resistant parasites such as Cryptosporidium and Giardia, harmful bacteria like E.Coli, and viruses not visible to the naked eye.
Specially designed and tested Sterilume™-HO lamps provide consistent and reliable ultraviolet output over the entire life of the lamp (9000 hours) to ensure continuous purification. High output lamps allow for a small footprint while providing the same UV performance as a standard output lamp in a longer chamber.
The system is simple to maintain and service, allowing for easy lamp replacement.
Built with a durable stainless steel chamber to prolong life and eliminate ultraviolet light degradation.
Safety-Loc™ connector with interlock ensures power is disconnected before the lamp can be removed.
The controller visually displays the remaining lamp life and will go into alarm if the lamp fails. Monitored systems are equipped with a UV sensor which provides a continuous readout of UV intensity.
Monitored systems allow for the installation of an optional solenoid valve which will stop the flow of water through the chamber should the UV performance fall below a safe level.

Specifications

MODEL	VH150	VH200	VH410	VH410M
FLOW RATES (@ 95% UVT)
US Public Health (16 mJ/cm²)	12 GPM (45 lpm) (2.7m³/hr)	16 GPM (60 lpm) (3.6 m³/hr)	34 GPM (130 lpm) (7.8 m³/hr)	34 GPM (130 lpm) (7.8 m³/hr)
VIQUA Standard (30 mJ/cm²)	5 GPM (19 lpm) (1.1 m³/hr)	9 GPM (34 lpm) (2.0 m³/hr)	18 GPM (70 lpm) (4.2 m³/hr)	18 GPM (70 lpm) (4.2 m³/hr)
NSF/EPA (40 mJ/cm²)	3.5 GPM (19 lpm) (0.8 m³/hr)	7 GPM (26 lpm) (1.6 m³/hr)	14 GPM (54 lpm) (3.3 m³/hr)	14 GPM (54 lpm) (3.3 m³/hr)
DIMENSIONS
Chamber	13" x 3.5" (33 cm x 8.9 cm)	17.75" x 3.5" (45 cm x 8.9 cm)	23.5" x 3.5" (59.6 cm x 8.9 cm)	23.5" x 3.5" (59.6 cm x 8.9 cm)
Controller	6.8" x 3.2" x 2.5" (17.2 cm x 8.1 cm x 6.4 cm)	7.25" x 3.25" x 2.5" (18.6 cm x 8.1 cm x 6.4 cm)	7.25" x 3.25" x 2.5" (18.6 cm x 8.1 cm x 6.4 cm)	9.25" x 3.25 x 2.5" (24 cm x 8.1 cm x 6.9 cm)
Inlet/Outlet Port Size	Combo 3/4" FNPT / 1" MNPT	3/4"-1" MNPT COMBO*	3/4"-1" MNPT COMBO*	3/4"-1" MNPT COMBO*
Shipping Weight	8 lbs (3.6 kg)	12 lbs (5.4 kg)	17 lbs (7.7 kg)	17 lbs (7.7 kg)
ELECTRICAL
Voltage	120-240V / 50/60 Hz	120-240V / 50/60 Hz	120-240V / 50/60 Hz	120-240V / 50/60 Hz
Power Consumption	32 W	35 W	60 W	60 W
Maximum Operating Pressure	125 psi (8.62 bar)	125 psi (8.62 bar)	125 psi (8.62 bar)	125 psi (8.62 bar)
Influent Water Temperature	2-40°C (36-104°F)	2-40°C (36-104°F)	2-40°C (36-104°F)	2-40°C (36-104°F)
FEATURES
Visual "Power On"	YES	YES	YES	YES
Chamber Material	304 SS	304 SS	304 SS	304 SS
Visual Lamp Life Remaining	YES	YES	YES	YES
Audible Lamp Life Failure	YES	YES	YES	YES
Audible Lamp Replacement Reminder	YES	YES	YES	YES
UV Sensor	NO	NO	NO	YES

* /2B - BSP

Replacement Parts

S150RL-HO - UV lamp for VH150
S200RL-HO - UV lamp for VH200
S410RL-HO - UV lamp for VH410 & VH410M
QL-150 - quartz sleeve for VH150
QL-200 - quartz sleeve, UV lamp combo pack for VH200
QL-410 - quartz sleeve, UV lamp combo pack for VH410 & VH410M
QSO-150 - quartz sleeve for VH150
QS-001 - quartz sleeve for VH200
QSO-410 - quartz sleeve for VH410 & VH410M
410867 - o-ring for quartz sleeves
RN-001 - retaining nut for all systems
RN-001/1 - retaining nut with plug for all systems
BA-ICE-CL - electronic ICE controller for VH150, VH200, VH410
BA-ICE-CM - electronic ICE controller VH410M

VIQUA VH150, VH200, VH410, & VH410M DOSE CURVES

A graph titled 'VIQUA VH150, VH200, VH410, & VH410M DOSE CURVES' plots UV dose (mJ/cm²) on the Y-axis against flow rate (GPM) on the X-axis. It shows separate curves for VH410 & VH410M (highest dose at given flow rate), VH200, and VH150 (lowest dose at given flow rate), illustrating how UV dose decreases as flow rate increases for each model. The X-axis ranges from 0 to 45 GPM, and the Y-axis ranges from 0 to 80 mJ/cm².

Water Quality Parameters

For optimal performance, the influent water should meet the following parameters:

Hardness: < 7 grains (120 mg/L)
Iron: < 0.3 mg/L
Tannins: < 0.1 mg/L

	VIQUA VH150, VH200, VH410, VH410M Ultraviolet Water Disinfection Systems Explore VIQUA's compact and reliable UV water disinfection systems (VH150, VH200, VH410, VH410M) for residential applications. Safeguard drinking water from harmful bacteria, Cryptosporidium, Giardia, and E.Coli with chemical-free UV purification, featuring durable stainless steel chambers and advanced monitoring.
	VIQUA VH200-F10 & VH410-F20 Ultraviolet Water Systems VIQUA's VH200-F10 and VH410-F20 are compact UV water systems with integrated pre-filtration, offering reliable and economical water treatment for residential and small business applications. Learn about their features, specifications, and replacement parts.
	VIQUA UV Water System Owner's Manual \| Installation, Operation, Maintenance Comprehensive owner's manual for VIQUA UV water purification systems, including models VH150, VH200, VH410, VP600, VP950, and M-series. Covers safety, installation, operation, maintenance, troubleshooting, and specifications for optimal water treatment.
	VIQUA UV Water Disinfection System Owner's Manual Comprehensive owner's manual for VIQUA UV water disinfection systems, including models VH150, VH200, VH410, VP600, VP950, VH410M, VP600M, VP950M, VH200-V, VH410-V, and VH410M-V. This guide covers installation, operation, maintenance, troubleshooting, and warranty information to ensure safe and effective water purification.
	VIQUA UV Water System Owner's Manual for VT1-DWS, VT4-DWS, VT4-DWS11 This owner's manual provides comprehensive information for VIQUA UV water systems, including models VT1-DWS, VT4-DWS, and VT4-DWS11. It covers installation, operation, safety precautions, maintenance procedures, water chemistry requirements, system specifications, and manufacturer's warranty details.
	VIQUA D4 UV Water System Owner's Manual and Installation Guide Comprehensive owner's manual and installation guide for the VIQUA D4 UV water system, covering safety, operation, maintenance, troubleshooting, and specifications. Learn how to install, operate, and maintain your UV water treatment system for optimal performance and safety.
	VIQUA IHS10-D4, IHS12-D4, IHS22-D4 UV Water System Owner's Manual Comprehensive owner's manual for VIQUA IHS10-D4, IHS12-D4, and IHS22-D4 UV water systems. Includes installation, operation, maintenance, troubleshooting, and warranty information.
	VIQUA Arros UV Water System Owner's Manual: Installation, Operation, and Maintenance Comprehensive owner's manual for VIQUA Arros UV water systems. Includes detailed instructions for installation, operation, safety precautions, maintenance procedures, and troubleshooting for models Arros 9, 15, and 22 series.

VIQUA VH150, VH200, VH410 & VH410M