Cleaning Instructions
Follow these steps to clean your Victor Electronic Mouse Trap:
- Separate Units: Turn off the power switch to "0" and remove the batteries. Hold the device as shown. Slide the chamber forward.
- Clean Chamber: Use only warm water, a soft brush, and a topical hydrogen peroxide solution. Ensure NO water contacts the electronics.
- Dry Chamber: Allow the inner and outer chamber to air dry completely.
- Dry Hands: Ensure your hands are thoroughly dry.
- Reassemble: Insert the assembly keys into their corresponding openings. Slide the chamber backward.
- Final Steps: Follow the trap's general operating instruction steps 1-7.
Operating Instructions
Learn how to set up and operate your Victor Electronic Mouse Trap:
- Power Off and Remove Batteries: Turn the trap OFF ("0") and remove the batteries.
- Baiting: Open the chamber door. Place a pea-sized amount of peanut butter into the bait cup only. Bait touching the metal plates may cause malfunction.
- Placement: Position the trap on a dry, clean surface along a wall, ensuring the rodent entrance faces the wall.
- Power Up: Insert 4 AA batteries into the battery compartment. Turn the power switch to the ON ("I") position. The green light will blink, and the unit will hum to indicate it is activated.
- Rodent Caught: A blinking GREEN light indicates a rodent has been caught (this status will persist for one week).
- Low Battery: A RED light indicates the batteries are low and need replacing.
- Disposal of Catch: Turn the trap OFF ("0") and remove the batteries. Open the chamber door and dispose of the rodent properly. Follow the trap's cleaning instructions.
Parts Identification
The Victor Electronic Mouse Trap consists of the following parts:
- 1: Chamber
- 2: Rodent Entrance
- 3: Assembly Keys / Hooks
- 4: Battery Compartment
- 5: Battery Cover
- 6: Electronics / Electronic Part
- 7: Power Switch
- 8: Status Light / LED Light
- 8a. GREEN: Rodent Caught (blinks for one week)
- 8b. RED: Replace Batteries
- 9: Bait Cup
- 10: Chamber Door
Safety Warnings
Please read and adhere to all safety warnings:
- Ignition Hazard: Use indoors on dry, clean surfaces only. Do not use near unventilated flammable vapors, liquids, or combustible solids. Avoid use in barns, stables, or similar wet or dusty locations.
- High Voltage Hazard: Keep out of reach of children and pets. Handle only with dry hands or rubber gloves. Always turn OFF the power and separate units before placing bait. Do not touch the metal plates when the unit is powered ON.
- Electromagnetic Waves: Maintain a distance of at least 30 cm (approximately 1 foot) from pacemakers or other life-support devices. Consult your physician if you experience any shock. Failure to read and follow all instructions and warnings may result in electric shock, fire, or serious injury. Read and follow all label instructions carefully.
- General Safety: This equipment generates, uses, and can radiate radio frequency energy. If not installed and used according to instructions, it may cause harmful interference with radio communications. There is no guarantee that interference will not occur in a particular installation. If the equipment causes harmful interference with radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Compliance and Regulatory Information
This apparatus complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this apparatus may not cause harmful interference, and (2) this apparatus must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by Woodstream Corporation may void the user's authority to operate the equipment.
European Compliance (CE): This apparatus may be used by children aged 8 years and above, and by persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge, if they have been given supervision or instruction concerning safe use of the apparatus and understand the hazards involved.
Canada Compliance: CAN ICES-3 (B)/NMB-3(B)
Product Information
Brand: Victor
Model: Electronic Mouse Trap Model M250S-N
Manufacturer: Woodstream Corporation
Address: 69 N. Locust St. Lititz, PA 17543
Contact: 1-800-800-1819 | www.victorpest.com
Supply: 6V
EPA Est. No.: 84504-VNM-001
U.S. Patents: 7,219,466, 7,010,882, 6,836,999, 6,796,081, 6,735,899
Manufactured in: Vietnam
