Victor Electronic Mouse Trap Instructions

TRAP OPERATION INSTRUCTIONS

1. Turn the switch to the "OFF" position and insert 4 AA batteries into the battery compartment.

   [Visual: Hands inserting batteries into the trap.]

2. Open the kill chamber door and bait trap with peanut butter in the indicated bait cup.

   [Visual: Trap with kill chamber door open, showing bait cup.]

3. Turn the switch to the "ON" position. The green light will flash and the unit will buzz to indicate the unit has been enabled. Once a rodent is caught, a green light will flash for up to one week.

   [Visual: Hand turning the power switch to 'ON'.]

4. Place the trap along a wall, making sure the side with the rodent entrance is against the wall.

   [Visual: Trap positioned against a wall.]

A red light indicates low battery life. Replace batteries.

TO DISPOSE OF RODENT

Turn the switch to "OFF". Open the kill chamber door and properly discard rodent.

TRAP CLEANING INSTRUCTIONS

1. Disassembly: Turn the switch to "OFF". Hold trap with battery compartment in left hand, power switch facing upwards and rodent entrance facing towards you.

   [Visual: Hands separating the trap's kill chamber from the housing.]

2. With your right hand push forward and separate the kill chamber from the electronics housing.

3. The kill chamber is now ready for cleaning. Open rodent disposal door. Use soft bristle brush and warm soapy water to scrub inside of chamber if desired.

   [Visual: Cleaning the kill chamber with a brush.]

4. Thoroughly dry interior and exterior of kill chamber prior to trap reassembly.

5. Assembly: Hold battery compartment in left hand with power switch facing upwards and align key holes. Insert keys into opposite openings and pull right hand backwards to reconnect halves.

   [Visual: Hands reassembling the trap.]

6. Trap is ready for use.