Vari Essential Filing Cabinet

Tools Needed

• 14mm Wrench
• Phillips Head Screwdriver (Not Included)

Parts Included

• Filing Cabinet x1
• Locking Casters x2
• Casters x2
• 10mm Lock Washer x4
• Anti-Tip Caster x1
• M4 X 10 Phillips Head Screw x2
• Key x1
• Filing Bar x1
• Pencil Tray x1

Assembly Steps

1. Step 1: Preparation

   Remove the filing cabinet from the box and place it upright. Unlock the cabinet and remove the hardware kit from the second drawer. Close and relock the cabinet. With assistance, carefully lift and rotate the cabinet upside down onto a carpet or blanket to prevent surface scratches.

2. Step 2: Install Casters

   Insert the threaded caster post through a lock washer and into the cabinet's threaded inserts. Place locking casters in the front two inserts and standard casters in the back two. Hand-tighten the caster posts, then use the wrench to fully secure them. Repeat for all four casters.

3. Step 3: Install Anti-Tip Caster

   Align the anti-tip caster with the pre-drilled holes on the bottom edge of the large drawer, ensuring the wheel faces away from the cabinet front. Use a Phillips head screwdriver to tighten the screws.

4. Step 4: Position Cabinet Upright

   Confirm the locking casters are in the locked position. With assistance, lift and rotate the cabinet to an upright position, setting it down gently on the casters.

5. Step 5: Install Pencil Tray and Filing Bar

   Unlock the file cabinet. Insert the pencil tray into the desired location in the top drawer. To install the filing bar, position it according to the diagram. Lower the bar into the drawer, place one end in a side slot, and rotate it until the other end fits into its corresponding slot. You may need to gently push the drawer side outward to facilitate rotation.

Caution: Weight Capacities

• First Drawer: 22 lb (10 kg)
• Second Drawer: 22 lb (10 kg)
• Third Drawer: 44 lb (20 kg)
• Top of Cabinet: 110 lb (50 kg)