Ciro Passenger Floorboard Mount Covers Installation Guide

Important Information

WARNING

This indication alerts you to the fact that ignoring the contents described herein can result in potential serious injury or death if not followed.

CAUTION

This indication alerts you to the fact that ignoring the contents described herein can or will result in material damage and/or personal injury.

ATTENTION

This indication alerts you to the fact if you ignore this detail you will affect the performance or functionality of the product.

Product Overview & Installation Recommendation

All Ciro products are designed for "easy assembly" and/or "plug and play". Ciro recommends a competent mechanic install their products, using standard mechanical procedures to assure a safe and successful installation. Read completely and understand the instructions prior to starting installation.

Warranty Note: Ciro products are designed and manufactured under very strict quality control. Ciro warrants products sold to the original purchaser against defects in materials and workmanship for a period of 3 (three) years from the date of purchase, and a limited lifetime warranty against LED failure. Ciro requires proof of purchase. Warranty is void if the part is not properly installed, unmodified, or maintained. Ciro is not liable for consequential or incidental damages, including labor or non-Ciro products. For the complete warranty policy, please visit Ciro3d.com.

Included Items

• 1 Right side cover
• 1 Left side cover

Product Visual Description

The product package includes two chrome-finished covers for passenger floorboards: one for the left side and one for the right side.

Installation Instructions

Part Numbers: 78180, 78181

1. Place the motorcycle on its center stand and allow the engine to cool.
2. Open the right saddlebag and remove the side cover panel. (Visual reference: Fig. 1 shows accessing the panel).
3. Remove two push darts and set them aside for reinstallation. To release, push the center pin of each dart until it clicks. (Visual reference: Fig. 2 illustrates the push dart release mechanism, showing a push-to-release action).
4. Remove the 3mm Allen screw located at the bottom of the cover. (Visual reference: Fig. 3 points to the 3mm Allen screw location).
5. Remove the 10mm hex bolt situated at the top left of the cover. (Visual reference: Fig. 4 points to the 10mm hex bolt location).
6. Pull the wire cable from its clip and remove the cover. This step applies only to the right side. (Visual reference: Fig. 5 shows the wire cable and clip that needs to be detached).
7. Transfer the grommet, wire cable clip (right side only), and bumper from the old cover to the new cover. (Visual reference: Fig. 6 details the components to be reused: grommet, wire cable clip, and bumper).
8. Install the new right side cover by performing the removal steps in reverse order.
9. The left side installation is identical to the right side, with the key difference being the absence of a wire clip on the left side cover.