Yale Rim Deadlock

1. Prepare Door

Select the side of the door for lock mounting. Place the template at the desired height, aligning Line 'A' with the door edge. Mark positions for the cylinder and mounting holes.

Drill a Ø32mm cylinder hole and four Ø3mm mounting holes. The template diagram indicates these hole positions and sizes.

Note for drilling: Drill the cylinder hole from both sides of the door to prevent splintering of the door face. The template shows a Ø32mm (1 1/4") cylinder hole and four Ø3mm holes.

2. Prepare Cylinder

Assemble the cylinder to the cylinder trim. Insert this assembly through the cylinder hole in the door.

Secure the backplate to the cylinder using the two connecting screws provided.

Adjust the tail bar so it projects 12mm beyond the inside of the door. The diagram illustrates the cylinder, cylinder trim, backplate, connecting screws, and tail bar.

3. Assemble Lock Body

While holding Lever 'C' in, assemble the lock body to the door. Ensure the tail bar engages with the slot at the back of the lock body.

Secure the lock body to the door using the four long wood screws supplied. The diagram shows the lock body, Lever C, tail bar, and long wood screws.

4. Prepare Door Jamb

Mortice the door jamb to accept the strike. For door gaps greater than 3mm, rebating of Face 'B' is not required.

Mark and drill the strike mounting holes. The diagram shows the strike and the door jamb (Face B).

5. Assemble Strike

Secure the strike to the door jamb using the four short wood screws. The diagram shows the strike being attached to the jamb.

Yale Guarantee

ASSA ABLOY warrants its YALE branded products against defects in workmanship and materials, subject to the limitations and exclusions set out in this Warranty. If, within the normal working life of a product, it is found to be defective, and none of the limitations and exclusions set out in this Warranty apply, ASSA ABLOY will supply the same or equivalent product free of charge. This is the only remedy granted by ASSA ABLOY under this Warranty.

Limitations

All electrical and electronic components used in ASSA ABLOY'S YALE range of products (excluding batteries) are guaranteed for a period of 12 months from the date of proof of purchase, unless stated otherwise.

Exclusions

This Warranty does not cover:

• Damage to or malfunction or failure of the YALE product caused or contributed to by: improper installation or failure to follow fitting instructions; improper maintenance; fair wear and tear; any modification or repair which has not been authorized by ASSA ABLOY; use of substitute or replacement parts or cylinders other than genuine ASSA ABLOY parts or cylinders; or use of batteries other than those specified by ASSA ABLOY.
• The cost of: removal and/or replacement of the YALE product; freight and/or travelling time; replacement batteries; or any modification or repairs to a YALE product, unless authorised by ASSA ABLOY.
• Damage to or deterioration of the plated finishes which are classified as soft finishes, and are subject to deterioration under some environmental conditions.
• Damage caused by corrosion when the Yale product is used in a corrosive environment.
• Personal injury, property damage or economic loss, however caused.

This Warranty is in addition to and not in substitution for any rights of the purchaser under individual local legislation where the product is sold.

An ASSA ABLOY Group brand