KALERUM

Overview

This document provides assembly instructions for the KALERUM handle. It includes necessary tools and step-by-step guidance.

Tools and Preparation

The following tools are typically required for assembly:

• Phillips head screwdriver
• Pencil
• Drill with a 5 mm (3/16 inch) drill bit
• Clamp

A diagram shows these tools. A red cross symbol ❌ indicates a method or tool that should not be used.

Assembly Process

The assembly process involves marking, drilling, and attaching the handle. Figures illustrate the steps:

• One figure shows a person assembling furniture, appearing confused (❓ symbol) with a partially assembled unit.
• Another figure, wearing a hard hat, is shown working on the furniture, with the IKEA logo visible.

Assembly Steps

Step 1: Marking Holes

Mark the desired hole positions on the furniture surface using a pencil. The recommended measurements from the edge are:

• 128 mm (5 1/16 inches)
• 256 mm (10 1/16 inches)
• 384 mm (15 1/8 inches)

Diagram description: A surface is shown with three pencil marks indicating the precise locations for drilling, measured from the edge.

Step 2: Drilling Pilot Holes

Using a drill, create pilot holes at the marked positions. The recommended drill bit size is Ø 5 mm (3/16 inches).

Diagram description: A clamp secures a piece of furniture while a drill with a 5 mm drill bit creates a hole at a marked spot.

Step 3: Attaching the Handle

Attach the KALERUM handle (part number 100414) to the furniture using the provided screws.

Diagram description: The KALERUM handle is shown being attached to the drilled holes. A screw and washer assembly, labeled with part number 100414, is depicted.