Sangean WR-9 Portable Bluetooth Radio

Important Safety Instructions

• Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.
• Only use attachments / accessories specified by the manufacturer.
• To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
• Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, shall not be placed on the apparatus.
• The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
• Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment and warranty.
• CAUTION: Risk of explosion if the battery is replaced by an incorrect type.
• Do not allow your radio to be exposed to water, steam or sand.
• Do not leave your radio where excessive heat could cause damage.
• Replacement of a battery with an incorrect type that can defeat a safeguard (for example, in the case of some lithium battery types).
• Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.
• Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas.
• A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
• To prevent possible hearing damage, do not listen at high volume levels for long periods.
• ⎓ The symbol indicates DC voltage.

CAUTION: To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.

Federal Communication Commission (FCC) Interference Statement

For United States:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Radiation Exposure Statement: The product complies with the FCC portable RF exposure limit set forth for an uncontrolled environment and is safe for intended operation as described in this manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Controls and Functions

Note: Fully charge the battery before using the radio for the first time.

Listening to Music via Bluetooth Streaming

Pairing and Playing Your Bluetooth Device for the First Time

1. Rotate the Mode knob to select the Bluetooth mode. The LED indicator will blink blue, indicating the radio is available for pairing.
2. Enable Bluetooth on your Bluetooth device (refer to its manual if unsure).
3. On your Bluetooth device, go to the Bluetooth list and select the device named “WR-9”.
4. Note: For older Bluetooth devices (v2.1 or earlier), you may need to enter a passcode: “0000”.
5. After pairing and connecting, a confirmation tone will sound, and the LED indicator will turn solid blue. You can now play music from your Bluetooth device through the radio’s speaker. Volume can be controlled from either device.
6. Use the controls on your Bluetooth-enabled device to play/pause and navigate tracks.

Disconnecting Your Bluetooth Device

Rotate the Mode knob to any mode other than Bluetooth, or turn off the Bluetooth function on your device to disconnect.

Supplied Accessories

• External antenna
• USB-A to USB-C charging cable

Specifications

Note: The barcode label on the product includes Serial number, Production month, Production year, and Product code. Sangean reserves the right to amend specifications without notice.

Recycling

This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.