Hilti X-SCO/N ALH37 Installation Guide

This procedure outlines the steps for fastening at distances less than 0.5 meters. It involves preparing the fastener, using the appropriate tool, and securing the connection.

Step 1: Prepare the fastener and the surface.

Step 2: Align the fastener with the tool.

Step 3: Drive the fastener into the material.

This procedure details fastening at distances greater than 0.5 meters. Similar to 3a, it involves preparation, alignment, and driving the fastener.

Step 1: Prepare the fastener and surface.

Step 2: Position the fastener and tool.

Step 3: Drive the fastener.

Step 4: Ensure secure fastening.

This section illustrates an alternative method for fastening, likely involving a different tool or accessory setup.

Step 1: Prepare the fastening strip.

Step 2: Load the fasteners into the tool.

Step 3: Position and drive the fasteners.

Step 4: Confirm secure installation.

Warning: This step highlights a critical safety consideration during installation. Ensure proper handling and alignment to avoid hazards.

This procedure specifies the correct depth for fastener insertion, indicated as 11-15 mm. Proper depth ensures optimal holding power.

Warning: This step emphasizes a potential hazard related to the material being fastened into. Red indicators suggest caution. Ensure the material is suitable for the fastening system.

For optimal performance and safety, use a minimum of 4 X-SCO/N fasteners per application. The DFTM designation may refer to a specific type of material or application environment.