Teltonika RUT360 Quick Start Guide v1.1

Hardware Overview

Front View

• Power socket
• Power LED
• SIM holder
• Mobile network type LEDs (3G, 4G)
• Mobile signal strength indication LEDs
• Ethernet ports (LAN, WAN)
• LAN LED
• WAN LED

Back View

• WiFi antenna connectors (x2)
• RESET button
• Mobile MAIN antenna connector
• Mobile AUX antenna connector

Power Socket Pinout

The power socket uses a 4-pin connector with the following pinout:

• Pin 1: Power / Red wire
• Pin 2: Ground / Black wire
• Pin 3: Input / Output / Green wire
• Pin 4: Input / Output / White wire

I/O Description: Programmable Input/Output pins. Supports Open Collector output (max 30 V, 300 mA) or Digital input (0-6 V for logic low, 8-30 V for logic high).

Hardware Installation

1. Push the SIM holder button with the SIM needle.
2. Pull out the SIM holder.
3. Insert your SIM card into the SIM holder.
4. Slide the SIM holder back into the router.
5. Attach Mobile and WiFi antennas.
6. Connect the power adapter to the device's power socket. Then plug the other end of the power adapter into a power outlet.
7. Connect to the device wirelessly using the SSID and password found on the device information label, or use an Ethernet cable connected to the LAN port.

Login to Device

1. Open your web browser and navigate to http://192.168.1.1.
2. Enter the username and password provided on the device label when prompted.
3. You will be required to change your password for security. The new password must be at least 8 characters long, including at least one uppercase letter, one lowercase letter, and one digit.
4. After changing the password, the Configuration Wizard will launch to help set up main operating parameters.
5. Navigate to the "Overview" page to check the Signal Strength indication. Adjust antennas or device location for optimal cellular performance.

Technical Information

Radio Specifications

Bundled Accessories Specifications*

*Order code dependent.

**Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for compliance with legal regulations.

Safety Information & Compliance

The RUT360 router must be used in compliance with all applicable national and international laws and special restrictions regulating the utilization of the communication module in prescribed applications and environments.

EU Declaration of Conformity

The device RUT360 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.

The full text of the EU declaration of conformity is available at: https://wiki.teltonika-networks.com/view/RUT360_CE/RED

General Instructions

Connect the power adapter to turn on the device. Open http://192.168.1.1 in your web browser to configure it. More information is available at: https://wiki.teltonika-networks.com/

Product Symbols

• WEEE Symbol: ? This sign means that all used electronic and electric equipment should not be mixed with general household waste.
• CE Symbol: ✅ This sign means that the product meets the requirements of the applicable EU directives.