YTBERG LED Cabinet Lighting

Important Safety Instructions

For indoor use only.

Regularly check the cord, the transformer, and all other parts for damage. If any part is damaged, the product should not be used.

Important information! Keep these instructions for future use.

The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire shall be replaced.

The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall be destroyed.

ONLY USE A SAFETY TRANSFORMER WITH A SELV OUTPUT AS A SUPPLY FOR THE PRODUCT.

Use only IKEA LED drivers suited for this product. The total wattage of the lamps connected to one LED driver must not exceed the maximum power stated on that LED driver and never more than 30W.

Installation Tape Instructions:

• Wipe the surface dry where the tape will be used with a clean and dry cloth.
• The assembly tape is permanent and is not intended to be removed. You might damage the surface under the lamp if you try to remove the tape.
• Please keep the unused fittings for future use.

CAUTION! Do not cover. Lamp gets hot, may cause fire. ?

WARNING – THIS IS AN ELECTRIC LAMP – NOT A TOY! TO AVOID RISK OF FIRE, BURNS, PERSONAL INJURY AND ELECTRIC SHOCK IT SHOULD NOT BE PLAYED WITH OR PLACED WHERE SMALL CHILDREN CAN REACH IT. ⚡️

Strangulation Hazard Warning:

Never place cord within reach of a child in a cot or playpen. Always secure cord to wall or cabinet. Check regularly that the cord is securely fastened. Pull the cord to remove any slack between fasteners. Tie up any remaining slack cord between driver and socket. ⚠️

Assembly Instructions

Parts Included:

• 2x Screws (Part #108553)
• 1x Mounting Bracket (Part #10084763)
• 1x LED Light Fixture

Step 1: Prepare and Mount Bracket

Clean the surface where the bracket will be attached with a clean, dry cloth. Measure and mark the desired location. Securely attach the mounting bracket to the wall or cabinet using the provided screws. Ensure the bracket is firmly fastened.

Step 2: Attach Light Fixture

Slide the LED light fixture onto the mounted bracket until it clicks into place.

Step 3: Connect Power

Connect the LED driver to the light fixture. Connect the power supply cord to the LED driver. Plug the power supply cord into a wall outlet.

Cable Management:

Secure any excess cable to the wall or cabinet using the provided fasteners to prevent tripping hazards and maintain a tidy appearance. Ensure the cable is not loose between the driver and the socket.

Product Information

LED Driver and Power Supply Cord: These items are sold separately.

Maximum Units: You can connect a maximum of 6 units to a single power supply system.

Light Adjustment: The light fixture can be rotated 180 degrees for directional lighting. Do not attempt to rotate it 360 degrees, as this may cause damage.