Lowrance Eagle 4x Installation and Mounting Template

Dimensions

Height: 116.0 mm (4.57 inches)

Width: 97.6 mm (3.84 inches)

Depth: 19.9 mm (0.78 inches)

Display Dimensions: 93.0 mm (3.66 inches) x 101.6 mm (4.00 inches)

Technical Data

Display Resolution: 272 x 480

Viewing Angle: 80° (top/bottom/left/right)

Electrical:

• Supply Voltage: 12 V DC (10.4-17 V DC)
• Power Consumption (max.): 2.34 W (195 mA at 12 V DC)
• Recommended Fuse: 3 A

Interface/Connectivity:

• Sonar: 1 Connector (compatible with Bullet Skimmer Transducer)

Environmental:

• Operating Temperature: -15 °C to 55 °C (5 °F to 131 °F)
• Storage Temperature: -20 °C to 60 °C (4 °F to 140 °F)
• Water Resistance: IPX7

Physical Data:

• Weight (Display Only): 0.28 kg (0.624 lb)
• Mounting Type: Panel or U-Bracket Mount

Accessories

The following accessories are available separately from your local dealer:

• Sun Cover: SKU: 000-16248-001
• Dash Gasket Kit: SKU: 000-16252-001

Trademarks

Reg. U.S. Pat. & Tm. Off and ™ Common Law marks. For more information on global trademark rights and accreditations of Navico Group and other companies, visit www.navico.com/intellectual-property. Navico® is a trademark of Navico Group. Lowrance® is a trademark of Navico Group. EAGLE® is a trademark of Navico Group.

Included in Delivery

• A: Eagle 4x Display
• B: U-Bracket Mount Kit
• C: Bullet Skimmer Transducer
• D: Cable Retainer
• E: Fuse and Fuse Holder
• F: Documentation

U-Bracket Mount

Step 1: Drill holes for the U-bracket. Recommended pilot hole size: Ø 3.8-4.8 mm (3/16 inch) for soft/hard materials.

Step 2: Attach the U-bracket to the display.

Step 3: Secure the display to the desired surface using the provided hardware.

Step 4: Connect the transducer and power cables.

Step 5: Secure the cables using the cable retainer.

Panel Mount

Step 1: Cut out the mounting hole according to the template provided (1:1 scale, A3 size: 420 mm x 297 mm / 16.54" x 11.69").

Step 2: Insert the display unit into the panel opening.

Step 3: Secure the display from behind using the mounting hardware.

Wiring

Connect the transducer cable and the power cable to the corresponding ports on the back of the display unit.

Cable Retainer

Step 1: Attach the cable retainer to the cables.

Step 2: Secure the cables to the unit.

Mounting Template

Note: Do not resize this mounting template when printing.

The template is provided at a 1:1 scale for A3 paper size (420 mm x 297 mm / 16.54" x 11.69").

Maximum dash curve: 0.5 mm (0.02 inches)

Safety Warning

WARNING: Always wear appropriate eye protection, hearing protection, and a dust mask when drilling, cutting, or grinding. When drilling or cutting, be aware of the back of all surfaces.