Lefant Quick Start Guide
1. Remove Protective Film
Remove the protective film on the robot and docking station.
2. Install Side Brushes
Click the side brushes into place.
3. Docking Station Placement and Power Connection
Place the docking station against the wall on a flat surface. Ensure there are no items within 0.5m to the left or right and 1.5m in front to avoid blocking the charging signal. Avoid reflective objects, such as floor mirrors, near the docking station to prevent signal reflection.
Clearance requirements:
- 0.5m to the left and right of the docking station.
- 1.5m in front of the docking station.
4. Charging
Place the robot with its button side facing the docking station. When the button light starts to blink, it indicates correct placement. The robot will turn on automatically if charging while powered off.
Indicator status during charging:
- Purple blinking light: Battery below 50%.
- Blue blinking light: Battery above 50%.
- No light: Battery fully charged.
5. Tidy Up the Room
Please remove any fragile and miscellaneous items from the floor (such as vases, plastic bags, etc.) to prevent the robot from being obstructed or causing damage to valuable items in the home due to minor collisions.
Do not use the robot in areas without protective barriers (like open balconies). Ensure balcony doors are closed, or use a sturdy physical barrier to prevent accidental falls that could cause injury or property damage.
6. Start Cleaning
Press the button to have the robot start the cleaning task from the docking station.
App Download and Configuration
Scan the QR code to download and install the Lefant App as prompted. Make an appointment to clean your home twice a day.
Warm tips:
- After the App is installed, please follow the page guide to complete account registration, login, and sweeper network setup.
- For the first time, the sweeper will automatically enter the network state when it is turned on. The device will be automatically scanned when you click "Add Device" in the App.
- The robot only supports 2.4GHz Wi-Fi network.
How to Use Buttons
- Hold for 3 seconds: Turn on
- Fast press: Start/Pause
- Fast press twice: Auto-recharge
- Hold for 6 seconds: Enter network pairing mode (Networking operation: Press and hold for 6 seconds and release when you hear two beeps, the light will blink and the robot will enter the networking mode. Please open the App for networking and pairing).
- Hold for 12 seconds: Turn off (a long "beep" indicates power off)
Indicator Meaning
| Robot Status | Indicator Status |
|---|---|
| Cleaning | Blue light on |
| Pause/standby | Blue light on |
| Charging | Purple/Blue Breathing |
| Low battery-automatic return and charge | Red light on |
| Enter network pairing mode | Purple light on |
| Distribution Network Success | Blue light flash |
| Error | Blue light on |
| Cleaning complete-automatic return and charge | Red light on/flash |
Product Information
Product Model: M310
Material Name: Quick Start Guide Cover (English)
Material Size: 356*298mm
Material: 300g double copper paper
Printing Requirements: Spot color printing + matte film
Material Number: 904-1091-0000
Version Number: V01 (12.22)
