STÖTTA LED Cabinet Lighting Strip

Step 1: Mark Mounting Points

Using a ruler and pencil, mark the positions where the mounting clips will be attached inside the cabinet. Ensure the marks are level and spaced appropriately for the lighting strip.

Step 2: Attach Mounting Clips

Use a screwdriver to fasten the two mounting clips to the marked positions using the provided screws. Ensure the clips are firmly secured to the cabinet surface.

Diagram Description: Shows a screwdriver being used to screw a mounting clip into the cabinet.

Step 3: Mount the Lighting Strip

Align the STÖTTA LED lighting strip with the attached mounting clips. Gently push or slide the strip onto the clips until it clicks or locks into place. Ensure the strip is stable.

Diagram Description: Shows hands guiding the lighting strip onto the mounted clips.

Step 4: Sensor Placement Considerations

The lighting strip is equipped with a sensor that activates the light. For optimal performance, position the strip so the sensor can detect the opening and closing of cabinet doors. A recommended distance 'X' from the door edge is indicated in the diagrams to ensure proper activation. Incorrect placement may lead to the light not functioning as expected [⚠️ warning symbol].

Diagram Description: Illustrates the lighting strip installed within a cabinet, with close-ups showing sensor positioning and a warning for incorrect placement.

Step 5: Understanding Operation Modes

The STÖTTA lighting strip features an "Auto Off On" function. This means the light automatically turns on when a door is opened and switches off after a short delay once the door is closed. The delay timer is typically set to around 3 minutes or 4 seconds, depending on the specific model or configuration.

Diagram Description: Shows the light turning on (?) when a door opens and turning off after a timer (⏳ 3 min or ⏳ 4 sec) when the door is closed.