Ryobi 18V 1 Gallon Electrostatic Sprayer Troubleshooting Tips & Tricks

1️⃣ Leaking From Front

Ensure all o-rings and nozzles are securely in place.

Tighten the nozzle selector.

Diagram description: Shows disassembled parts of the nozzle selector with arrows indicating tightening.

2️⃣ Liquid Will Not Spray / Pump Will Not Prime

Set the nozzle selector to "High" and force water or air through the back of the unit to clear any blockage.

Fill the hose with liquid by connecting the hose to the tank and pressing down on the metal bar inside the connector on the hose.

Diagram description: Shows the Ryobi sprayer unit and a hose with a connector. Arrows indicate the flow of air or water.

3️⃣ Nozzle Selector Freely Spinning

Confirm that detent ball and spring are in place.

Diagram description: Two diagrams show the nozzle selector mechanism. The top diagram shows the correct placement of the ball and spring with a green checkmark. The bottom diagram shows incorrect placement with a red cross mark.

4️⃣ Further Assistance

If you do not see your issue listed here, or you need further assistance, please reach out to our electrostatic sprayer customer support team.

READ ALL INSTRUCTIONS BEFORE USING APPLIANCE

• Do not use bleach, alcohol-based chemicals, chlorine, hypochlorous acid, or hydrogen peroxide.
• Do not use tablets, powder, or abrasive chemicals.
• Do not combine chemicals.
• The RYOBI P2870 Electrostatic Sprayer is compatible for use with most water soluble chemicals. For a list of compatible chemicals, please refer to the Compatible Chemicals List below.
• Please continue to periodically check the list, as it is updated often.
• Before using any of the listed cleaning chemicals please refer to the Compatible Chemicals QR code below.