Snooker SK-80P Ice Maker

Electrical Requirements

⚠️ A 115 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply is required. Ensure the supply is properly grounded in accordance with the National Electrical Code and local codes and ordinances.

It is recommended that a separate circuit serving only the ice maker be provided. Use a receptacle that cannot be turned off by a switch or pulled by a chain.

Water Requirements

? A cold water supply with water pressure between 0.13 MPa (19 psi) and 0.55 MPa (80 psi) is required to operate the ice maker. For questions regarding water pressure, consult a licensed, qualified plumber.

Location Requirements

? To ensure proper ventilation, the front side of the ice maker must be completely unobstructed. The unit may be closed in on the top and two sides, but installation should allow the ice maker to be pulled forward for servicing if necessary.

• Installation requires a cold water supply inlet of 1/4" (6.35 mm) OD soft copper tubing with a shutoff valve.
• Alternatively, a drain pump may be used to carry water to an existing drain.
• Choose a well-ventilated area with temperatures above 55°F (13°C) and below 110°F (43°C). Optimal results are achieved between 70°F and 90°F (21°C and 32°C).

Unit Dimensions

The ice maker unit dimensions are provided for planning purposes. The front view shows a height of 31.5 inches, a width of 20 inches, and a depth of 18 inches. Side and rear views are also illustrated, indicating connection points and component layout. Refer to the product's installation instructions for complete details. Specifications are subject to change without notice.

Pre-Installation Checks

• Verify the power supply cord is not damaged, pinched, or kinked between the ice maker and the cabinet.
• Verify the water supply line is not damaged, pinched, or kinked.
• Verify the drain line (on applicable models) is not damaged, pinched, or kinked.
• Choose a location where the floor is even. The ice maker must be level to operate properly. Adjust leveling legs if necessary.

Drain Connection

Gravity Drain System

Connect the ice maker drain to your drain system in accordance with all state and local codes and ordinances. For gravity drain systems, follow these guidelines to prevent water from flowing back into the storage bin or onto the floor:

• Drain lines must have a minimum of 5/8" (15.88 mm) inside diameter.
• Drain lines must have a 1" drop per 48" (2.54 cm drop per 122 cm) of run, or a 1/4" drop per 12" (6.35 mm per 30.48 cm) of run.
• Ensure drain lines do not have low points where water can settle.
• Floor drains must be large enough to accommodate drainage from all connected drains.
• An ideal installation uses a standpipe with a 1 1/2" (3.81 cm) to 2" (5.08 cm) PVC drain reducer installed directly below the drain tube outlet. Maintain a 1" (2.54 cm) air gap between the drain hose and the standpipe.

Important Notes on Drains

IMPORTANT: A drain pump is necessary when a floor drain is not available.

IMPORTANT: Adhere to Plumbing Code and any local codes and ordinances.

• The drain pump discharge line must terminate at an open sited drain.
• Maximum rise for a drain pump discharge line is 10 ft (3.1 m).
• Maximum run for a drain pump discharge line is 100 ft (30.5 m).

Additional Notes

• If the drain hose becomes twisted and prevents drainage, the ice maker will not function.
• Consider insulating the drain line thoroughly up to the drain inlet.

At Snooker, our policy includes a continuous commitment to improve our products. We reserve the right to change materials and specifications without notice.