Origin 21 Southaven Standing Light

Preparation and Assembly

Before beginning assembly, ensure all parts are present by comparing them with the package contents and hardware lists. Do not assemble if any part is missing or damaged.

Estimated Assembly Time: 20 minutes. No additional tools are required.

Thank you for purchasing this Origin 21 product. For more information, visit Lowes.com, search the item number, and refer to the Guides & Documents tab. For questions, contact customer service at 1-888-251-1026 (8 a.m. - 8 p.m. EST, Monday - Sunday) or partsplus@lowes.com, or visit www.lowespartsplus.com.

Package Contents

• Part A: Base (x1)
• Part B: Lower Pole Section (x1)
• Part C: Upper Pole Section (x1)
• Part D: Lamp Holder Pole (x1)
• Part E: Lamp Holder Assembly (x1)
• Part F: Lampshade (x1)
• Part G: Finial/Cap (x1)
• Part H: Pole Connector/Coupler (x4)

Hardware Contents

• AA: Bolts (x3)
• BB: Bolts (x2)
• CC: Washer (x1)
• DD: Allen Wrench (x1)

Assembly Steps

Assemble on a soft surface, such as a carpet, to avoid scratching the product.

1. Step 1: Attach the base (A) to the lower pole section (B) using three bolts (AA). Hand tighten AA. Do not tighten completely until all bolts have been installed.
2. Step 2: Connect the upper pole section (C) to the lower pole section (B) using two bolts (AA) and two bolts (BB). Hand tighten AA and BB. Once all bolts are installed and hand-tightened, go back and tighten firmly with the provided Allen wrench (DD).
3. Step 3: Join the upper pole section (C) to the lamp holder pole (D) using the pole connectors (H). Slide the connectors into the ends of the poles to secure them.
4. Step 4: Attach the lamp holder assembly (E) to the lamp holder pole (D) by screwing on the finial/cap (G).
5. Step 5: Place the lampshade (F) onto the lamp holder assembly (E).

The final assembly results in the Southaven Standing Light.

Care and Maintenance

• Before use, clean the product completely with a soft, dry towel.
• When not in use, wipe free of dirt or loose objects, wash with a mild soap and water solution, rinse, and dry completely.
• Do not use strong detergents or abrasive cleaners.
• Store the product in a cool, dry location away from sunlight.

Warranty

This warranty extends to the original purchaser and applies to defects in materials and workmanship for patio furniture, provided it is maintained with care and used for personal, residential purposes only.

Frames are warranted against defects in material or workmanship for one (1) year.

Cushions, straps, and/or wicker weaves are covered for one (1) year against defects in material or workmanship.

Safety Information

Please read and understand this entire manual before attempting to assemble, operate, or install the product.

Warnings:

• Tighten each bolt firmly and properly. Do not completely tighten screws until all screws are started.
• Some parts may contain sharp edges. Wear protective gloves as necessary.
• Children under 16 should not be involved in assembly, removal, or disassembly.
• Children under 10 should be supervised by a competent adult while using this furniture.
• Keep children out of the assembly area during assembly.
• This set is heavy and may require two adults for safe assembly.
• Never use this product as a support. Do not shake, lean, or climb on the product at any time.

Cautions:

• Do not overtighten bolts, as this may damage threads.
• Repeated assembly can weaken the locking ability of washers.
• Periodically check all bolted connections to ensure they are tight and secure.
• Retain these instructions for future reference.
• Paint may peel if the product is hit or used improperly. Use and carry with care, and apply touch-up paint (not included) when necessary.
• This outdoor furniture is designed for personal, non-commercial use.
• Do not use this item as a toy or tool.
• Do not locate the product near any heat source.