Corston Oxford Handle Instructions
Handle Types
The Oxford handle can be fitted to Shaker Front 1, Shaker Front 2, and Slab Front doors.
Please Note: Oxford handles can be mounted horizontally & vertically.
Installation Steps
- Use the printed template to mark the hole positions in the desired handle location.
- Drill holes for the handle with a 6.5mm drill bit.
- Trim screws to correct length if too long.
- Screw handle into position.
Mounting Templates
The following templates are provided for accurate handle placement:
36mm Oxford Handle Mounting Template
Instructions: Fold here for flush fit.
Measurements indicated: 10mm, 20mm, 30mm, 40mm.
128mm Oxford Handle Mounting Template
Instructions: Fold here for flush fit.
Measurements indicated: 10mm, 20mm, 30mm, 40mm.
224mm Oxford Handle Mounting Template
Instructions: Fold here for flush fit.
Measurements indicated: 10mm, 20mm, 30mm, 40mm.
384mm Oxford Handle Mounting Template
Instructions: Please stick page 5 & 6 together. Fold here for flush fit.
Measurements indicated: 10mm, 20mm, 30mm, 40mm.
Contact & Support
For further assistance, please visit corston.ae/support or email hello@corston.ae.
