TOPDON CarPal Quick User Guide
Thank you for purchasing the TOPDON CarPal. This quick user guide will walk you through the basic setup and operation of the CarPal wireless diagnostic dongle. For the best user experience, carefully read and follow all the instructions and warnings.
Download & Install the APP
Please go to the App Store or Google Play and search for the "TopDon CarPal" to download and install the App.
After installation, you can log in to your account using your email and the verification code you received. If you do not have an account, your email address will be used to register an account automatically the first time you log in.
Setup and Operation
-
Plug the CarPal into the vehicle's OBD-II port.
The vehicle's OBD-II port is usually located under the dashboard.
[Illustration of CarPal being plugged into a car's OBD-II port]
-
Turn the ignition to the "ON" position.
The red LED light on the CarPal indicates it is powered on.
[Illustration showing ignition switch positions: LOCK, ACC, ON, START]
-
Start the first vehicle health check.
Tap "Vehicle Health Check" to start the first vehicle health check and get your vehicle's rating.
[Illustration of the app interface showing the 'Vehicle Health Check' option]
-
Bluetooth Connection
When the LED light is solid green, you can begin the Bluetooth connection. When a connection is established, the LED light on the device will turn solid blue, and the VCI will be activated automatically.
[Illustration showing CarPal device connecting via Bluetooth to a smartphone]
Tap "Next" to start Bluetooth searching. When the connection is established, the LED light will turn solid blue.
[Illustration of app showing successful activation]
Your CarPal is now ready for use.
Updates
The installed vehicle-specific software can be seen on the software download page. When a new version is available, an "Update" button will display. Tap the button to update the software.
For firmware updates, tap "Mine" > "Firmware Update" to update the firmware if a new version is available.
FAQ
Q: What should I do if a communication error occurs?
Follow the steps below to identify the problem:
- Check if the ignition is ON.
- Check if the CarPal is securely plugged into the vehicle's OBD-II port.
- Turn the ignition off. Then, turn it on after 10 seconds and continue the operation.
- Check if the vehicle's control module is defective.
Q: What special functions does the CarPal support?
The CarPal supports 6 special functions, including Oil Reset, Throttle Reset, EPB Reset, BMS Reset, TPMS Reset, and DPF Regeneration.
Q: Do I need to update the firmware before using it for the first time?
Yes. Firmware will automatically update to the latest version once the CarPal is connected with your phone via Bluetooth. You can also tap "Mine" > "Firmware Update" to update the firmware manually.
Q: Can multiple devices be bound to one TopDon CarPal App account?
Yes.
FCC Compliance Information
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
