TREATLIFE RF Remote Control

Need Help?

✉️ Support@treatlife.tech

Tech Support: www.treatlife.tech/pages/support

Add Devices

• Press and hold the switch power button for 5 seconds to enter pairing mode, then press and hold the remote control power button for 1 second to confirm.

• Adjusting the Minimum Brightness:

  Method 1:

  1. Press and hold the power button on the remote for 6 seconds to enter minimum brightness adjustment mode.
  2. Use the [+] and [-] buttons to adjust the brightness in 1% increments.
  3. Once the desired brightness is set, press the power button for 1 second to confirm.

  Method 2:

  1. Press and hold the [+] and [-] buttons simultaneously for 3 seconds to enter minimum brightness adjustment mode.
  2. Use the [+] and [-] buttons to fine-tune the brightness in 1% increments.
  3. Once the desired brightness is reached, press the main button for 1 second to confirm.
• Press and hold the [-] button on the remote control for about 15 seconds to clear the remote control.
• Quickly press the switch power button three times to reverse the white load indicator.
• Press the reset button if the device is stuck or experiencing issues like being unable to adjust brightness (this will not reset the factory default minimum brightness).
• The minimum brightness setting will be saved even after a power outage.

Product Appearance

The remote control features several buttons for operation:

• Top Remote Diagram: Features an ON/OFF button, a [+] button for increasing brightness, and a [-] button for decreasing brightness.
• Middle Remote Diagram: Features an ON/OFF button, a [+] button for increasing brightness, and a [-] button for decreasing brightness.
• Bottom Remote Diagram: Shows three buttons labeled [Button 1 ON/OFF], [Button 2 ON/OFF], and [Button 3 ON/OFF].

Indicator Light Status

Battery Installation/Replacement

Follow these steps for battery installation or replacement:

Step 01: [Open Battery Compartment]

Step 02: [Insert Battery]

Step 03: [Close Battery Compartment]

Common Issues:

• If the light is flashing, try increasing the minimum brightness (refer to the Minimum Brightness Setting Steps).
• If the minimum brightness is too bright, try decreasing it (refer to the Minimum Brightness Setting Steps).
• If the remote control is unresponsive or not working properly, check the socket or the bulb if the issue persists.
• If the remote control is unresponsive or not working properly, it may be due to low battery power. Please replace the CR2032 battery.

⚠️ WARNING

a) Remove and immediately recycle or dispose of used batteries according to local regulations, and keep them away from children. Do NOT dispose of batteries in household trash or incinerate them.

b) Even used batteries may cause severe injuries or death.

c) Call a local poison control center for treatment information.

d) Battery: CR2032

e) Voltage: 3V

f) Non-rechargeable batteries are not to be recharged.

9) Do not force discharge, recharge, disassemble, heat above the manufacturer's specified temperature rating, or incinerate. Doing so may result in injuries due to venting, leakage, or explosions resulting in chemical burns.

a) Ensure the batteries are installed correctly according to polarity (+ and -).

b) Do not mix old and new batteries, different brands, or types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.

c) Remove and immediately recycle or dispose of batteries from equipment not used for an extended period of time according to local regulations.

d) Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children.

⚠️ INGESTION HAZARD:

This product contains a button cell or coin battery. DEATH or serious injury can occur if ingested.

A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.

KEEP new and used batteries OUT OF REACH of CHILDREN

Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.

FCC Caution:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RSS (Category I Equipment):

This device complies with Innovation, Science, and Economic Development Canada's licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d' Innovation, Sciences et Ddveloppement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :

1. l'appareil nedoit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectri- que subi, même si le brouillage est suscepti- ble d'en compromettre le fonctionnement.

The device is compliance with RF exposure guidelines, users can obtain Canadian information on RF exposure and compliance. The minimum distance from body to use the device is 20cm.

Le présent appareil est conforme

Après examen de ce matériel aux conformit6 ou aux limites d'inten- sité de champ RF, les utilisateurs peuvent sur l'exposition aux radiof- réquences et la conformité and compliance d'acquérir les informations correspondantes. La distance minimale du corps à utiliser le dispositif est de 20cm.

THANK YOU

If you have any questions, please feel free to contact us first. We are always here for you.