Installation Diagram

Installation Steps

1. Remove fixture from its original package.
2. Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2f).
3. Attach mounting plate (1c) to electrical junction box (1a) using screws provided (1d) in hardware package.
4. To change fixture height, push and hold wire gripper (2g), slide wire to desired length and then release wire gripper (2g) to secure (Remove excess wire if necessary).
5. Secure mounting plate (1c) to mounting surface with anchors (1f) and screws (1e).
6. Make proper electrical connections (black to hot "L", white to neutral "N", ground to "GND") with wire nuts (1b) provided in hardware package.
7. Attach canopy (2a) to mounting plate (1c) with canopy screws (2f) and nuts (2c), tighten them (2f and 2c).
8. Fine tune wire length if necessary, by push and hold wire gripper (2g) and then adjust wire to desired length.

Cable Adjustment

1. To shorten the cable: just push the cable up, cable will be locked Automatically.

2. To lengthen the cable: lift up on the cable and push up on the lock while keep the lock depressed, lower the cable to the desired length, release the lock to set.

Diagrams and Visuals

Safety Warning: A symbol indicating a power switch in the 'OFF' position is shown, along with a warning triangle and the text 'OFF'.

Mounting Plate and Canopy Assembly: A diagram illustrates the components for mounting the fixture. Key parts are labeled with numbers and letters: 1c (mounting plate), 2a (canopy), 2f (canopy screws), 1f (anchors), 1e (screws), 1a (electrical junction box), 1d (screws), 1b (wire nuts), 2g (wire gripper), 2c (nuts).

Wire Gripper Mechanism: A close-up illustration shows the wire gripper (2g) with a label indicating 'push' to adjust the wire.

Electrical Connections: A diagram shows a terminal block with labels 'ON' and 'F', indicating connection points for electrical wiring.