BRAYER BR4910 Ultrasonic Humidifier

How it Works

High-frequency vibration of the lamp divides water into the smallest particles of 1-5 micron in size. Cold water 'mist' mixes well with the air and increases the relative air humidity. A comfortable room humidity level should be from 40% to 60%. Insufficient room air humidity (especially during the heating season) negatively affects humans' and pets' health as well as plants and furniture.

Description

The humidifier consists of the following parts:

1. Lid with 'mist' release nozzle
2. Water tank
3. Process chamber with 'sprayer'
4. Indicators of operating modes (HUM, Sleep)
5. On/off/operating mode selection/relative humidity indication button (Ο)
6. Body

Illustrations show the humidifier's components and assembly steps (Pic. 1, Pic. 2, Pic. 3).

Safety Measures and Operation Recommendations

Read the operation instructions carefully before using the ultrasonic air humidifier, and keep them for future reference.

• Use the unit for its intended purpose only, as specified in this manual.
• Mishandling the unit can lead to its breakage and cause harm to the user or damage to the user's property, which is not covered by warranty.
• Make sure that the operating voltage of the unit indicated on the label corresponds to your home mains voltage.
• Place and use the Ultrasonic humidifier on a flat, dry, and water-resistant surface. The distance to the walls, other furniture, and interior objects should be at least 30 cm.
• Do not place the Ultrasonic humidifier near computers or other sensitive electronic appliances.
• Do not place the unit on carpet surfaces with high pile.
• Do not use the Ultrasonic humidifier outdoors.
• It is not recommended to use the unit during lightning storms.
• Protect the unit from impacts, falling, vibrations, and other mechanical stress.
• Never leave the unit connected to the mains unattended.
• Do not use the unit near heating appliances, heat sources, or open flame.
• Do not use the unit in places where aerosols are used or sprayed, and close to inflammable liquids.
• Do not use the unit in proximity to the kitchen sink, in bathrooms, near swimming pools, or other containers filled with water.
• If the unit is dropped into water, unplug it immediately, and only then you can take the unit out of water.
• Do not let the power cord touch hot surfaces and sharp edges of furniture.
• Unplug the unit after usage or before cleaning. When unplugging the unit, hold the power plug and carefully remove it from the mains socket; do not pull the power cord, as this can lead to its damage and cause a short circuit.
• Do not touch the unit body, the power cord, or the power plug with wet hands.
• Use only the removable parts supplied with the unit.
• Use tap water cleaned with domestic water filters, distilled, or boiled water. The water temperature should not exceed +40°C.
• Do not use sparkling or dirty water; do not add any perfume additives into the water tank.
• Do not switch the unit on without the water tank or if the water tank is empty.
• Switch the Ultrasonic humidifier off when the water tank is empty.
• Unplug the unit before removing the water tank.
• Do not cover the Ultrasonic humidifier during operation.
• Do not cover the air inlets on the unit body and avoid getting foreign objects inside them.
• Do not immerse the Ultrasonic humidifier, the power cord, or the power plug into water or any other liquids.
• Do not move or tilt the unit during operation; do not remove the water tank.
• Switch the unit off and unplug it, pour the water out of the tank and the process chamber during cleaning or when you do not use the unit.
• Unplug the unit before moving it to another place. Be careful when carrying the unit; hold it by the body with both hands.
• Clean the unit regularly.
• For child safety reasons, do not leave polyethylene bags used as packaging unattended.

ATTENTION! Do not allow children to play with polyethylene bags or packaging film. Danger of suffocation!

• The unit is not intended for usage by children.
• Do not leave children unattended to prevent using the unit as a toy.
• Do not allow children to touch the operating surface, unit body, power cord, or power plug during operation of the unit.
• Close supervision is necessary when children or disabled persons are near the operating unit.
• During the unit's operation and breaks between operation cycles, place the unit out of reach of children.
• The unit is not intended for usage by physically or mentally disabled persons (including children) or by persons lacking experience or knowledge if they are not under supervision of a person who is responsible for their safety or if they are not instructed by this person on the usage of the unit.
• Regularly check the integrity of the power cord.
• If the power cord is damaged, it should be replaced by the manufacturer, a maintenance service, or by similar qualified personnel, to avoid danger.
• Do not repair the unit by yourself. Do not disassemble the unit by yourself; in case of any malfunction or if the unit is dropped, unplug it and apply to the service center.
• To avoid damages, transport the unit in its original package only.
• Keep the unit in a dry, cool place out of reach of children and disabled persons.

THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY. DO NOT USE THE UNIT FOR COMMERCIAL OR LABORATORY PURPOSES.

Before the First Use

After the unit's transportation or storage at negative temperature, unpack it and wait for 3 hours before using it.

• Use the humidifier at room temperature from +10°C to +40°C and relative humidity less than 80%.
• Unpack the unit and remove all packaging materials.
• Keep the original package.
• Read the safety measures and operating recommendations.
• Check the delivery set.
• Examine the unit for damages; in case of damage, do not plug it into the mains.
• Make sure that the indicated specifications of the power supply voltage of the unit correspond to your mains voltage. When using the unit in mains with 60 Hz frequency, no additional settings are needed.

Using the Air Humidifier

• Remove the lid (1) from the reservoir (2) (fig. 1).
• Fill the water tank (2) with the required amount of water.
• Note: If the tap water used is hard, use water cleaned with household filters or mix tap water with distilled water in proportion 1:1.
• Install the lid (1) on the reservoir (2) (fig. 3).
• Wait until the process chamber (3) is filled with water.
• Insert the power plug into the mains socket. You will hear a beep.
• Switch the air humidifier on by pressing the button (5) 'Ο'. The humidifier operating modes will be displayed by the indicators (4) 'ὁ ὁ ὁ HUM Sleep'.
• By repeatedly pressing the button (5) 'Ο', select the humidification intensity level ('ὁ ὁ ὁ'), the mode of maintaining the relative humidity in the room ('Ο' HUM) or the night mode ('o' Sleep).
• In the mode of maintaining the relative humidity ('Ο' HUM), the humidifier will automatically set the humidification intensity, displayed by indicators (4) 'ὁ ὁ ὁ', depending on the relative humidity in the room.
• The relative humidity in the room is indicated by the colored illumination of the button (5) 'Ο':
  • Orange - low relative humidity;
  • Green - relative humidity in the room corresponds to the humidity installed by default;
  • Blue - high relative humidity.
• By repeatedly pressing the button (5) 'o' Sleep, select the night mode 'o'. In night mode, the humidifier switches on with minimum humidification intensity, and the indicator (4) 'o' lights up.
• If the water tank (2) is empty, the button (5) 'Ο' lighting will turn red.
• Remove the power plug from the mains socket.
• Fill the tank (2) with water, install it in place, and switch the unit on.
• After operation, switch the air humidifier off and unplug the power cord plug from the mains socket.

Cleaning and Maintenance

WARNING! Always switch the Ultrasonic humidifier off and unplug it before maintenance works or cleaning.

• Hard water causes mineral scale inside the process chamber (3), on the sprayer, and in the water tank (2). Mineral scale leads to improper operation of the humidifier.
• It is recommended to clean the process chamber (3) and the sprayer weekly, and to change water in the water tank (2).
• If you are not going to use the Ultrasonic humidifier for a long time:
  • Pour the water out of the water tank (2) and the process chamber (3).
  • Wash and clean the process chamber (3) and the sprayer.
  • Wash the water tank (2).
  • Dry the unit thoroughly and take it away for storage.

Weekly Care

• Once a week, wash the water tank (2), the process chamber (3), and the sprayer with warm water and a neutral detergent, and rinse thoroughly with water.
• Add a few drops of detergent onto the sprayer and wait for several minutes. Remove deposits from the sprayer surface with a brush.
• Note: Scale removal substances for electric kettles can be used for cleaning the process chamber (3) and the sprayer; strictly follow the instructions for these agents.
• Clean the unit body (6) with a slightly damp cloth and then wipe the body (6) dry.
• Do not immerse the unit body (6), the power cord, or the power plug into water or other liquids. Ensure that no liquid gets inside the unit body (6).
• Do not use solvents or abrasives to clean the surface of the body (6) and the water tank (2).

Storage

• Clean the Ultrasonic humidifier before taking it away for storage. Ensure that the Ultrasonic humidifier parts are dry. Pack the Ultrasonic humidifier in the original package.
• Do not store the unit with remaining water in the tank (2) and the process chamber (3).
• Keep the Ultrasonic humidifier in a dry, cool place out of reach of children and disabled persons.

Troubleshooting

Technical Specifications

Delivery Set

1. Ultrasonic humidifier assembled - 1 pc.
2. Manual - 1 pc.

Specifications

• Power supply: 220-240 V, ~50-60 Hz
• Rated input power: 26 W
• Water tank capacity: 4.0 l
• Water discharge: ≥ 300 ml/h
• Humidified area: up to 30 sq.m.

Recycling

To prevent possible damage to the environment or harm to the health of people by uncontrolled waste disposal, after expiration of the service life of the unit or the batteries (if included), do not discard them with usual household waste. Take the unit and batteries to specialized stations for further recycling. The waste generated during the disposal of the unit is subject to mandatory collection and consequent disposal in the prescribed manner.

For further information about recycling of this product, apply to your local municipal administration, a disposal service, or the shop where you purchased this product.

Manufacturer Information

Manufactured for: Ruste GmbH, Berggasse 18/18, 1090 Vienna, Austria.

Produced for Ruste GmbH, Berggasse 18/18, 1090 Vienna, Austria.

Manufactured by order of Ruste GmbH, Berggasse 18/18, 1090 Vienna, Austria.

Authorized manufacturer representative: OOO 'Grantel', 143912, Moscow region, Balashikha, Enthusiasts highway, bldg. 1A. Tel: +7 (495) 297-50-20, e-mail: info@brayer.pro.

Made in China.

Product Lifespan

The manufacturer reserves the right to change the appearance, design, and specifications not affecting general operation principles of the unit, without prior notice.

The unit operating life is 3 years.

The manufacturing date is specified in the serial number.

In case of any malfunctions, promptly apply to the authorized service center.