Honeywell Home DC315XX Wireless Doorbell Quick Start Guide

Getting Started

This guide provides essential steps to set up your Honeywell Home DC315XX wireless doorbell.

Package Contents:

• 1x Doorbell Chime
• 1x Push Button
• 2x Screws
• 2x Wall Plugs
• 1x CR2032 Battery (for Push Button)
• 4x AA/LR6 Batteries (for Chime)
• 1x Screwdriver (6mm)

Initial Setup Steps:

1. Mounting the Chime: The chime can be wall-mounted. Ensure a spacing of approximately 30mm between mounting points.
2. Mounting the Push Button: The push button can be wall-mounted. Ensure a spacing of approximately 15mm between mounting points.
3. Install Push Button Battery: Open the push button casing. Insert the CR2032 battery, observing polarity (+). Close the casing.
4. Install Chime Batteries: Open the chime casing. Insert 4x AA/LR6 batteries, observing polarity (+). Close the casing.
5. Test Functionality: Press the push button to confirm the chime rings.
6. Prepare Mounting Surface: Clean the desired mounting surface for the push button and chime.
7. Attach Mounting Plate: Secure the mounting plate for the push button to the cleaned surface.
8. Secure Push Button: Attach the push button to its mounting plate.

Optional Features: Chime Tones

Your doorbell offers various chime tones. To change the tone:

1. Press the music note button on the chime.
2. Continue pressing to cycle through available tones.

Linking the Doorbell Components

To link the push button and chime:

1. Initiate Linking on Chime: Press and hold the linking button on the chime for approximately 12 seconds until an indicator light or sound confirms it's in linking mode.
2. Activate Push Button: Press the push button. The chime should respond, indicating successful linking.

Troubleshooting Linking:

If linking fails or the chime does not respond:

• Attempt 1: Repeat the linking process.
• Attempt 2: If still unsuccessful after 3 hours, try again.
• Attempt 3: If still unsuccessful after 6 hours, try again.
• Attempt 4: If still unsuccessful after 9 hours, try again.
• Attempt 5: If still unsuccessful after 12 hours, try again.

Ensure the components are within range and batteries are correctly installed.

Troubleshooting and Support

If you encounter issues, try the following:

1. Reset/Re-link: Press and hold the linking button on the chime for approximately 12 seconds to reset and re-initiate the linking process with the push button.

For a full guide and further troubleshooting, visit the Honeywell Home support website.

• livewell.honeywellhome.com

Download full guide: Download Guide