Philips LEDtube Installation Guide

Packing List

The package typically contains:

• Philips LEDtube: 10 pieces
• EMP (LED replacement starter): Available as accessories

Symbols and Meanings

Key symbols and their interpretations:

• 50/60Hz: Lamp suitable for 50Hz or 60Hz operation.
• [?] Not Dimmable: This lamp is not dimmable.
• [?] LED Replacement Starter Required: Must be used with an LED replacement starter (EMP).
• [?] Dry Conditions: Need to be used in dry conditions or in a luminaire that provides protection.
• [❌] Not for Emergency Use: This lamp is not suitable for use in emergency luminaires.
• [?] Double-Capped Design: Designed for double-capped fluorescent lamp(s).

Important Notes and Warnings

• No modifications to the luminaire are to be made, other than replacing the starter with the EMP starter.
• This lamp may not be suitable for all applications where traditional fluorescent lamps were used, as its temperature range is more restricted. Consult the manufacturer if unsure about suitability.
• The LEDtube is designed for general lighting service and is not suitable for explosive atmospheres.
• Always switch off the power supply before commencing any work.
• Philips LED tubes should be installed by qualified professionals in accordance with relevant codes.
• Stick the provided Warning Sticker on the luminaire after modifications are made.
• The LEDtube is not suitable for DC voltage.
• This lamp is not suitable for use with electronic ballasts (EVG).
• Ensure that required lighting levels are met after switching to LEDtube.

Installation Steps

Follow these steps carefully for luminaires with conventional electromagnetic ballasts (KVG/VVG):

1. Turn off the power supply. [⚡️ OFF]
2. Remove the existing fluorescent lamp. [?➡️]
3. Remove the existing starter. [⚙️➡️]
4. Insert the EMP replacement starter. [⚙️➡️?]
5. Install the Philips LEDtube with the light opening facing downwards. [?⬇️]
6. Turn on the power supply. [⚡️ ON]

Note: For luminaires with conventional electromagnetic ballasts (KVG/VVG), only the starter needs to be replaced. No other modifications to the luminaire are required.

For luminaires with electronic ballasts (EVG), this LEDtube is not compatible.

For luminaires with a capacitor installed in parallel with the ballast or in the same circuit: remove the capacitor if it is in parallel with the ballast, or short the capacitor if it is in the same circuit.

Alternatively, for some systems, a blanking plug may be installed instead of the starter.

Energy Efficiency Information

The Philips LEDtube is designed for energy efficiency. The energy efficiency class ranges from A++ to G, as indicated on the product packaging and labels.

Example: The product may be rated as Class C for energy efficiency.

Legal and Manufacturer Information

©2019 Signify Holding. All rights reserved. Reproduction in whole or in part is prohibited without prior written consent.

The information provided is believed to be accurate and reliable but may be changed without notice. Signify Holding accepts no liability for any consequences of its use.

Publication does not convey any license under patent or other industrial or intellectual property rights.

For more information, visit: www.philips.com/lighting

Manufacturer: Signify GmbH, Lighting Division.