Installation Guide
Philips LEDtube
Product Overview
Philips LEDtube offers an energy-saving, LED-based alternative to traditional fluorescent tubes. It is designed for use with G13 bases according to IEC standards.
Packing List
- Philips LEDtube: 10 pcs
- EMP (LED Replacement Starter): available as accessories
Symbols and Meanings
| Symbol | Meaning |
|---|---|
| 50/60Hz | 50/60Hz Operation |
| [Not for Dimmers] | Do not use with dimmers |
| [Requires LED Replacement Starter] | Requires LED Replacement Starter EMP |
| [For Dry or Protected Luminaires Only] | For dry conditions or protected luminaires only |
| [Not for Emergency Use] | Not suitable for emergency luminaires |
| [For Double-Capped Lamps] | Designed for double-capped fluorescent lamps |
Important Notes and Warnings
- This product is not valid in Germany, Austria, and Switzerland.
- No modifications to the luminaire are required, other than replacing the starter.
- This lamp may not be suitable for all applications where traditional fluorescent lamps were used, due to a more restricted temperature range. Consult the manufacturer if unsure about suitability.
- Designed for general lighting service (not for explosive atmospheres).
- Philips LED tubes should be installed by qualified professionals in accordance with relevant codes.
- Stick the Warning Sticker on the luminaire after modifications are made.
- The LEDtube is not dimmable.
- The LEDtube is not suitable for DC voltage.
- For luminaires with conventional electromagnetic ballasts (KVG/VVG) only. Not suitable for electronic ballasts (EVG).
- When switching to LEDtube, verify that required illuminance levels are met.
- The lamp must only be used in dry environments or in a luminaire approved for the application with appropriate IP protection.
- Important for fixtures with Electromagnetic Ballasts (EMPRA): If a capacitor is installed in the same electrical circuit as the ballast, it must be handled as follows: Remove the capacitor if it is installed in parallel with the ballast. Short-circuit the capacitor if it is in the same circuit.
Installation Steps
Always switch off the power supply before commencing work.
- Turn off the power supply.
- Remove the fluorescent lamp.
- Remove the existing starter.
- Install the EMP replacement starter.
- Install the Philips LEDtube with the light opening facing downwards.
- Turn on the power supply.
Energy Efficiency
The product features energy efficiency labels indicating classes from A++ to G. The LEDtube itself is rated within the higher efficiency categories, typically A+ or A.
Manufacturer Information
©2019 Signify Holding. All rights reserved. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document is believed to be accurate and reliable and may be changed without notice. No liability will be accepted by the publisher for any consequence of its use. Publication thereof does not convey nor imply any license under patent or other industrial or intellectual property rights. Visit www.philips.com/lighting for more information.
