Bosch FLEXIDOME IP Camera Quick Installation Guide

Step 1: Identify Components and Tools

The following components and tools are required for installation:

• Camera unit
• Mounting screws: 6x30 mm (x6), T4x30 mm (x6), 4.5x40 mm (x1)
• Anchors (if needed)
• T20 Torx driver
• Micro SD card slot
• Reset button
• Menu button
• Optional: NBN-MCSMB connector

Step 2: Assemble Camera Base and Dome

Attach the camera dome to the mounting base. Secure the dome using six T4x30 mm screws.

Step 3: Prepare Mounting Surface

Drill holes in the mounting surface according to the template. The required hole diameter is approximately Ø(6-7) mm. Ensure a clearance of at least 7 mm [0.3 in] and 8 mm [0.3 in] for cable entry.

Step 4: Mount Camera Base

Secure the camera base to the mounting surface using the provided screws (e.g., 6x30 mm, 4.5x40 mm) and anchors if necessary.

Step 5: Connect Cables

Connect the necessary cables to the camera. This includes power, Ethernet (PoE), audio, and alarm connections. The camera supports 12 VDC / 24 VAC power input (SELV Class 2, 24-28 AWG wiring). The Ethernet connection defaults to DHCP, or uses Auto-IP (169.254.x.x) if no DHCP server is available. Ensure proper grounding if using a power adapter.

• RJ45 Ethernet [PoE]
• SMB connector [optional]
• BNC connector
• Audio connector
• Alarm connector
• Power input terminals: GDN, IN, OUT

Step 6: Install Micro SD Card

Insert a Micro SD card into the designated slot if local storage is required.

Step 7: Connect Network and Power

Connect the Ethernet cable for network access and the power supply. The diagram shows connections for Power, Ethernet (PoE), Audio, and Alarm.

Step 8: Adjust Camera Orientation

The camera allows for 350° pan and 350° twist adjustment. Ensure the light sensor is not positioned below the edge of the cover, especially for IR versions.

Step 9: Fine-tune Tilt and Focus

Adjust the camera's tilt up to 130°. Use the menu controls to adjust focus and zoom. The menu options include:

• On
• 180°
• Default
• Focus - autofocus
• Zoom (0-6)
• Zoom OK - autofocus
• Focus & Zoom OK
• Analog format
• Output OK

Step 10: Configure Camera Settings

Use the 'MENU' and 'RE' buttons to navigate camera settings. The available settings shown are related to focus, zoom, and output format.

Step 11: Final Assembly

Complete the camera assembly by securing any remaining parts, such as the dome cover, using T20 screws.

Step 12: Install Camera

Mount the assembled camera to its final location.

Step 13: Software and Resources

Download and use the Bosch Project Assistant App, Configuration Manager, and Video Security Client for Windows, iOS, and Android. Access downloads at: https://downloadstore.boschsecurity.com/

Contact Information:

Bosch Security Systems B.V.
Torenallee 49
5617 BA Eindhoven
Netherlands
www.boschsecurity.com

Document Version: 2022.02 | V09 | F.01U.329.066 | 202202181254