TP-Link Kasa Smart Wi-Fi Outdoor Plug KP400 User Guide

About This Guide

This guide provides a brief introduction to the Kasa Smart Wi-Fi Outdoor Plug and the Kasa app, along with regulatory information. Please note that product features may vary slightly based on model, software version, location, language, and internet service provider. All images, parameters, and descriptions are for demonstration purposes only.

Conventions

Key information is presented in teal. Hyperlinks are in teal and underlined, allowing navigation to websites.

More Info

• Specifications are available on the product page: https://www.tp-link.com
• Technical Support and troubleshooting information can be found at: https://www.tp-link.com/support

Introduction

Extend your smart home to the outdoors with the weather-resistant Kasa Smart Wi-Fi Outdoor Plug. Control patio lights, holiday decorations, and more from your smartphone. You can turn each outlet on/off individually, set schedules, and use voice commands with Alexa, Google Assistant, or Microsoft Cortana.

• Double the Outlets: Control two outdoor devices independently from anywhere using a single smart plug.
• Weather-resistant: Ideal for controlling patio lights, sprinklers, and other outdoor devices.
• Control from Anywhere: Manage your outlets and schedules remotely via the Kasa Smart app.
• Voice Control: Use voice commands with Alexa, Google Assistant, or Microsoft Cortana.
• No Hub Required: Works with a secured 2.4GHz wireless network without needing a separate hub.
• Set Schedules: Schedule individual devices connected to your plug for automatic on/off times.

Supported Load Types

Appearance

The Kasa Smart Wi-Fi Outdoor Plug features two individual smart outlets, each with a control button for turning the connected device on or off. A System LED indicates the current status, changing color based on different states.

System LED Status

• Orange: Rebooting.
• Blinking Orange and Green: Setup mode initiated.
• Blinking Green: Searching for Wi-Fi.
• White: Connected to Wi-Fi network successfully.
• Blinking Orange: Resetting.
• Red: No Wi-Fi connection.

Smart Outlet

Smart Outlet x 2: Plug in your devices and control them from your smartphone. Each outlet operates independently.

LED of Smart Outlet

Lit up when the corresponding smart outlet is on.

Control Button

Control Button x 2: Press the control button to turn the corresponding outlet on or off. Press and hold for 5 seconds to re-enable setup mode. Press and hold for 10 seconds to restore the plug to factory default settings.

Set Up Your Smart Outdoor Plug

Follow these steps to set up your smart outdoor plug using the Kasa Smart app:

1. Download and install Kasa app: Go to Google Play or the Apple App Store, or scan the QR code to download the Kasa app on your Android or iOS smartphone or tablet.
2. Log in or sign up with TP-Link ID: Open the app and log in using your TP-Link ID. If you don't have one, tap "Create Account" and follow the app's instructions.
3. Add Device: Tap the '+' button in the Kasa app, select "Smart Outdoor Plug," and follow the step-by-step app instructions to complete the setup.

[Description of app screenshots showing download options, login screen, and device selection.]

Main Device Controls

After successful setup, the Kasa app's home page displays the status of all added devices. You can manage them and control individual outlets (HS107 models).

Kasa App Interface

[Description of Kasa app Home Page showing a list of devices like Smart Bulbs, Smart Plugs, Smart Router.]

[Description of Kasa app Device Status screen for a 'Night Light' plugged into 'Plug 2', showing controls like Schedule, Timer, Away mode.]

Configure Your Smart Outdoor Plug

From the Device Status page in the Kasa app, you can configure various settings for your smart outlets:

Set Schedule

Tap the [Schedule Button] to create a schedule for your smart outlet, automating daily on/off actions.

[Description of app screen for setting a schedule, including time, days of the week.]

Preset Away Mode

Tap the [Away Button] to preset Away Mode, which will randomly turn your smart outlet on/off during the specified time to simulate occupancy.

[Description of app screen for setting Away Mode, including start and end times, and repeating days.]

Configure Your Smart Outdoor Plug (Continued)

Set Timer

Tap the [Timer Button] to set a timer, after which your smart outlet will automatically turn on or off.

[Description of app screen for setting a timer.]

Check Usage

Tap the [Usage Button] to view and track energy consumption for your connected devices.

[Description of app screen showing energy usage statistics like Current Runtime, Total Runtime, Daily Average.]

Device Settings

Tap the [Settings Button] to view and change your smart outlet's settings, such as renaming, setting icons, or configuring remote control and integrations.

[Description of app screen for Device Settings, showing options like Remote Control, Name and Icon, Customize, Advanced.]

Create Scenes

A scene is a preset group of smart devices that can be programmed, customized, and activated simultaneously with a single button press from your smartphone or tablet. Scenes allow you to easily set your mood, activity, or prepare for special occasions by automating how your smart home devices behave.

[Description of Kasa app Scenes screen showing a 'Generic Movie' scene.]

Discover Kasa

Integrate your Kasa Smart Wi-Fi Outdoor Plug with Amazon Alexa, Google Home Assistant, or Microsoft Cortana for a hands-free experience. IFTTT support enables easy interaction with a wide range of products.

To set up these integrations, launch the Kasa app and navigate to Add Device > WORKS WITH KASA, then select the desired service (e.g., Nest Home and Away, Amazon Alexa, Google Assistant, IFTTT) for detailed instructions.

[Description of Kasa app 'Add Device' screen showing 'WORKS WITH KASA' options.]

Authentication

COPYRIGHT & TRADEMARKS

Specifications are subject to change without notice. TP-Link is a registered trademark of TP-Link Technologies Co., Ltd. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced or used to make derivatives without permission from TP-Link Technologies Co., Ltd. Copyright © 2018 TP-Link Technologies Co., Ltd. All rights reserved.

FCC Compliance Information Statement

Product Name: Kasa Smart Wi-Fi Outdoor Plug

Model Number: KP400

Responsible party: TP-Link USA Corporation, d/b/a TP-Link North America, Inc.

Address: 145 South State College Blvd. Suite 400, Brea, CA 92821

Website: http://www.tp-link.com/us/

Tel: +1 626 333 0234

Fax: +1 909 527 6803

E-mail: sales.usa@tp-link.com

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

"To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter."

TP-Link USA Corporation has determined that the equipment shown complies with applicable technical standards, FCC part 15. No unauthorized changes have been made to the equipment, and it is properly maintained and operated.

Issue Date: 2018-08-31

Canadian Compliance Statement

This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two conditions:

1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:

1. L'appareil ne doit pas produire de brouillage;
2. L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

Déclaration d'exposition aux radiations:

Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps.

Industry Canada Statement

CAN ICES-3 (B)/NMB-3(B)

NCC Notice

注意! 依據低功率電波輻射性電機管理辦法 第十二條 經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性或功能。 第十四條低功率射頻電機之使用不得影響飛航安全及干擾合法通行;經發現有干擾現象時,應立即停用,並改善至無干擾時方得繼續使用。前項合法通信,指依電信規定作業之無線電信。低功率射頻電機需忍受合法通信或工業、科學以及醫療用電波輻射性電機設備之干擾。

BSMI Notice

安全諮詢及注意事項 (Safety Advice and Precautions)

• 請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。(Use the original power adapter or only use the product according to the specified power type.)
• 清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。(Unplug the power cord before cleaning. Do not use liquids, spray cleaners, or damp cloths for cleaning.)
• 注意防潮,請勿將水或其他液體潑灑到本產品上。(Beware of moisture, do not spill water or other liquids onto the product.)
• 插槽與開口供通風使用,以確保本產品的操作可靠並防止過熱,請勿堵塞或覆蓋開口。(Slots and openings are for ventilation to ensure reliable operation and prevent overheating; do not block or cover openings.)
• 請勿將本產品置放於靠近熱源的地方。除非有正常的通風,否則不可放在密閉位置中。(Do not place the product near heat sources. Do not place in enclosed spaces without proper ventilation.)
• 請不要私自打開機殼,不要嘗試自行維修本產品,請由授權的專業人士進行此項工作。(Do not open the casing yourself, do not attempt to repair the product yourself; entrust this work to authorized professional personnel.)

限用物質含有情況標示聲明書 (Statement on the Restriction of Hazardous Substances)

備考1. "超出 0.1 wt%" 及 "超出 0.01 wt %" 系指限用物質之百分比含量超出百分比含量基準值。(Note 1: "Exceeds 0.1 wt%" and "Exceeds 0.01 wt %" refer to the percentage content of the restricted substance exceeding the percentage content threshold.)

備考2. " " 系指該項限用物質之百分比含量未超出百分比含量基準值。(Note 2: " " refers to the percentage content of the restricted substance not exceeding the percentage content threshold.)

備考3. "-" 系指該項限用物質為排除項目。(Note 3: "-" indicates that the restricted substance is exempt.)

Safety Information

• Keep the device away from water, fire, humidity, or hot environments.
• Do not attempt to disassemble, repair, or modify the device.
• Do not use the device where wireless devices are not allowed.
• The socket-outlet shall be installed near the equipment and shall be easily accessible.
• Operating Temperature: 0°C~40°C (32°F-104°F)
• Operating Humidity: 10%~90%RH, Non-condensing

Additional Safety Information & Warnings

• Storage Humidity: 5%~90%RH, Non-condensing.
• For outdoor usage, use this product with a ground fault circuit interrupter (GFCI) outlet.
• Risk of electric shock. Do not open. No user-serviceable parts inside.
• Do not immerse into water.
• Refer servicing to qualified service personnel.

Please read and follow the above safety information when operating the device. TP-Link cannot guarantee that no accidents or damage will occur due to improper use. Please use this product with care and at your own risk.

WARNING

• Timers could turn on unexpectedly without the user being present. To reduce the hazardous condition, unplug the appliance plugged into the receptacle(s) controlled by the timer before servicing.
• Risk of Electric Shock. Do not plug into another relocatable power tap or an extension cord.
• When plugged into a grounded 3-prong outlet, always ensure the housing is facing downward and is at least 2 feet off the ground. Use the plug's mounting tag to hang from a screw to ensure correct orientation.
• DO NOT expose to heavy rain or immerse in water or any other liquid.
• DO NOT remove the ground pin (middle pin) or use with a 3-to-2 prong adapter.
• DO NOT use with devices that should not be operated unattended, such as power tools.
• DO NOT use in precision timing applications where inaccurate timing could be dangerous (e.g., sunlamps, saunas).
• Keep children away from the Smart Plug and outlet.
• No serviceable parts inside. DO NOT open or tamper with the unit.
• Do not discard the stopper; the plug should be covered when the socket is not in use.
• Remove the Smart Plug from the outlet before cleaning.
• DO NOT clean with liquid.
• DO NOT exceed the recommended electrical ratings.

Explanation of the symbols on the product label