Timex Mini Simple Digital Watch

Features

This digital watch offers the following functions: TIME, DATE, SECONDS.

Water and Shock Resistance

If your watch is water-resistant, meter marking or () is indicated.

*pounds per square inch absolute

WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER WATER.

• Watch is water-resistant only as long as crystal, crown and case remain intact.
• Watch is not a diver watch and should not be used for diving.
• Rinse watch with fresh water after exposure to salt water.
• Shock-resistance will be indicated on the watch face or caseback. Watches are designed to pass ISO test for shock-resistance. However, care should be taken to avoid damaging the crystal.

Operation

• Press the MODE (A) button to move from time to date.
• Press the MODE (A) button again to move from date to seconds.
• Press the MODE (A) button again to move from seconds back to time.

Setting

• Press the RESET (B) button twice to enter the setting mode. The month will be displayed.
• Press the MODE (A) button to advance the number to the correct month.
• Press the RESET (B) button again to display the day of the month.
• Press the MODE (A) button to advance the number to the correct day of the month.
• Press the RESET (B) button again to display the hour.
• Press the MODE (A) button to advance the number to the correct hour (A= AM, P= PM).
• Press the RESET (B) button again to display the minutes.
• Press the MODE (A) button to advance the number to the correct minutes.
• Press the RESET (B) button again to exit the setting mode.

How to Adjust Bracelet

(Variations of the following bracelet sections apply to all watch models).

Sliding Clasp Bracelet

1. Open locking plate.
2. Move clasp to desired bracelet length.
3. Exert pressure while holding locking plate and slide clasp back and forth until it engages in grooves on underside of bracelet.
4. Press locking plate down until it snaps closed. Clasp can be damaged if excessive force is used.

Foldover Clasp Bracelet

1. Find spring bar that connects bracelet to clasp.
2. Using a pointed tool, push in spring bar and gently twist bracelet to disengage.
3. Determine wrist size, then insert spring bar in correct bottom hole.
4. Push down on spring bar, align with top hole and release to lock in place.

Bracelet Link Removal

Removing Links:

1. Place bracelet upright and insert pointed tool in opening of link.
2. Push pin forcefully in direction of arrow until link is detached (pins are designed to be difficult to remove).
3. Repeat until desired number of links are removed.

Re-Assembly:

1. Rejoin bracelet parts.
2. Push pin back into link in opposite direction of arrow.
3. Press pin down securely into bracelet until it is flush.

International Warranty

For warranty information, please visit: https://www.timex.com/productWarranty.html

©2024 Timex Group USA, Inc. TIMEX is a registered trademark of Timex Group USA, Inc. in the US and other countries.