Ezlo Plus
Superior home control, sleek design & cutting-edge technology.
Reset Button & LED Behavior Guide
A sleek, dark grey, oval-shaped home control hub with ventilation slots is shown.
ezlo innovation
Details
Back View
The reset button requires a pin or paperclip to be pressed.
Ports visible: Reset button, USB, Ethernet, Power.
Front View
LED Indicator is visible.
Reset Button Actions
| RESET BUTTON ACTION | RESULT ACTION | LED STATUS |
|---|---|---|
| 1 short (0.05 - 0.5 seconds) press within 1.5 second | Send the broadcast message to cloud server | Two blinks |
| 2 short (0.05 - 0.5 seconds) presses within 1.5 second | Reset client connection Wi-Fi settings | Fast blinking (4 times per second) |
| 3 short (0.05 - 0.5 seconds) presses within 1.5 second | Perform hub Power off action | Fast blinking (twice per second) |
| One long (2 - 5 seconds) press | Reboot controller | Fast blinking (twice per second) |
| One long (5 - 10 seconds) press | Soft reset | Slow blinking (once per second) |
| One long (10 - 20 seconds) press | Factory reset | |
| Holding more than 20 seconds | Cancel factory reset start |
Reset Logic
| HUB ELEMENT | SOFT RESET | HARD RESET |
|---|---|---|
| Included devices | Remove from hub, left in included state | Remove from hub, left in included state |
| Z-Wave network ID | Change to random value | Change to random value |
| WiFi settings | Don't change | Restore to defaults |
| Backups stored at controller | Don't change | Remove |
| Plugins data | Remove | Remove |
| Other user data | Remove | Remove |
| User addons and plugins | Don't change | Remove |
| Default addons and plugins | Don't change | Restore to defaults |
Note: Holding more than 20 seconds will cancel the factory reset.
LED Status Meanings
The following table describes various operational states and their corresponding LED indicators:
| Operational State | LED Indicator Pattern |
|---|---|
| Booting/Power on | (Pattern not specified) |
| Firmware is running and there is nothing else to notify | (Pattern not specified) |
| System has booted but firmware not | (Pattern not specified) |
| Firmware update | Slow blinking (once per second) |
| The controller has connection to the Internet but it cannot establish connection with Cloud | Fast blinking (twice per second) |
| Process of adding new smart device is started | Slow blinking (once per second) |
| Process of removing smart device is started | Fast waving (twice per second) |
