Introduction
The Stinger SPXSH440 SwitchHub is a versatile 4-channel, 100-amp solid-state relay hub designed for both automotive and marine environments. This guide provides essential information to get you started with your new SwitchHub.
Key Features
- Four independent outputs: one 40-amp and three 20-amp channels, with a total continuous output of 100 amps.
- Each output can be independently triggered by a positive or negative signal.
- Outputs can be combined for applications requiring higher amperage.
- Automatic thermal overload protection for each output.
- LED status indicators for each output (Green: Active, Red: Thermal/Short Protection, Off: Inactive).
- Suitable for both marine and off-road applications.
Overview
The SwitchHub simplifies accessory power management by providing a centralized and robust solution. Its solid-state design offers reliability and efficient power distribution for various electronic accessories.
Installation and Wiring
For detailed installation and wiring instructions, please refer to the full user manual. Key connection points include:
- Main Power Input: Connect to the vehicle's positive battery terminal. An inline fuse is recommended if the power source is over 18 inches away.
- Module Ground: Connect to the vehicle's chassis ground.
- Negative Triggers (1-4): Activate corresponding outputs when a negative signal is applied.
- Positive Triggers (1-4): Activate corresponding outputs when a positive signal is applied.
- Power Outputs (1-4): Provide +12V when triggered.
Always disconnect the vehicle's negative battery cable before making any wire connections. Ensure all wiring is properly insulated and secured to prevent damage.
Support and Warranty
Stinger products are backed by a limited one-year warranty covering defects in materials and workmanship. For service or warranty information, please contact Stinger support:
- Phone: 727-592-5991
- Email: support@aampglobal.com
- Website: www.stingerelectronics.com
Stinger is a Power Brand of AAMP Global.
