Zippo Butane Torch

General Safety Instructions

Read all instructions before use. Keep this manual for future reference.

• This product is not a toy. Keep out of reach of children.
• Use only in well-ventilated areas.
• Do not expose to temperatures exceeding 50°C (122°F).
• Do not puncture or incinerate, even when empty.
• Do not use near open flames, hot surfaces, or flammable materials.
• Ensure the torch is completely cool before storing.
• Do not attempt to modify or repair the torch.
• Handle with care to avoid dropping or damage.
• Always point the torch away from yourself and others when operating.

Diagram shows a Zippo Butane Torch with various warning symbols indicating potential hazards like heat, flame, and the need for ventilation.

Operating Instructions

To operate the Zippo Butane Torch:

1. Ensure the torch is properly filled with butane.
2. Hold the torch upright and point the nozzle away from any person or flammable object.
3. Press and hold the ignition button. The flame will ignite.
4. To adjust the flame height, turn the adjustment dial located near the nozzle. Turn clockwise for a higher flame and counter-clockwise for a lower flame.
5. To turn off the torch, release the ignition button. The flame will extinguish.

Diagram illustrates the torch operation: a hand pressing the ignition button, a flame emerging from the nozzle, and an arrow indicating the direction of the adjustment dial.

Filling Instructions

To refill the Zippo Butane Torch:

1. Ensure the torch is completely cool and turned off.
2. Turn the torch upside down.
3. Locate the filling valve at the base of the torch.
4. Insert the nozzle of the butane canister firmly into the filling valve.
5. Press the butane canister down for 5-10 seconds to fill. Repeat if necessary, allowing the torch to rest between fills.
6. Allow the torch to sit upright for a few minutes before igniting to allow gas to stabilize.
7. If the torch is overfilled, wait for excess butane to evaporate before igniting.

Diagram shows a butane canister with its nozzle inserted into the filling valve at the bottom of the inverted torch.

Adjusting the Flame

The flame height can be adjusted using the adjustment dial:

• Turn the dial clockwise to increase flame height.
• Turn the dial counter-clockwise to decrease flame height.
• Adjust to the desired flame size for your application. A small, stable flame is recommended for most tasks.

Diagram shows a close-up of the torch's adjustment dial, with arrows indicating the direction for increasing and decreasing flame height.

Troubleshooting

Torch does not ignite:

• Ensure the torch is filled with butane.
• Check if the adjustment dial is set too low.
• Ensure the ignition button is being pressed correctly.

Flame is weak or sputtering:

• The torch may need refilling.
• The flame adjustment may be set too low.
• Ensure the butane is at room temperature.

Torch leaks butane:

• Ensure the filling valve is properly sealed after filling.
• If leakage persists, discontinue use and contact Zippo customer support.

Product Care and Maintenance

• Clean the exterior of the torch with a soft, dry cloth.
• Do not use abrasive cleaners or solvents.
• Store in a cool, dry place away from direct sunlight.
• Ensure the torch is completely cool and empty before long-term storage.