SereneLife SLPAC8 Portable Air Conditioner, Fan, and Dehumidifier

Important Safety Tips

Precautions

Please read the Manual carefully before operating the machine:

• This machine is for household use only.
• This machine is for indoor use only. Please place it in a dry environment.
• Check the power cord frequently. If the power cord, plug, or A/C is damaged, please do not operate. If the power cord is not long enough, a power extension cable can be used. The cable should not be placed where it can be pulled out or cause people to stumble.
• The A/C should be kept away from heat sources and direct sunlight.
• Turn off the A/C before unplugging.
• Turn off and unplug the A/C before removing or cleaning it, or replacing its parts, or when it is not in use.
• Clean the A/C according to the Manual.
• The voltage of the A/C should meet requirements. Any damage incurred by incorrect power is not included in the warranty.
• Children are not allowed to play with the A/C. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Do not insert your fingers or any hard object into the wind guide bar of the air outlet.
• Do not place the A/C in any place with water or other liquid. Prevent water or liquid from entering the A/C.
• Do not repair the A/C yourself. Any possible hazard incurred by maintenance by laypeople will violate the warranty. If the supply cord is damaged, it must be replaced by professional maintenance personnel.
• Please use the accessories provided by the A/C manufacturer; otherwise, the A/C may be damaged.
• Suggest using environmental temperature for the air conditioner (Cooling): 15°C-35°C or 59°F-95°F.

This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

Special Warning:

• Place the A/C on even ground and install it vertically to ensure normal operation of the compressor.
• The A/C should be at least 50cm away from surrounding objects. Keep air inlet and outlet smooth.
• Do not use the A/C beside gasoline or any other inflammable liquid.
• Do not use spraying agents and other solvents or flammable substances near the A/C; otherwise, its plastic may deform and electric parts may be damaged.

Power

• The plug should be in good condition and not be damaged. Do not replace the plug with a power plug.
• In order to run the A/C, plug the power cord first, and then press the power key.

Product Introduction

Main Parts and Components

1. Handle
2. Control panel
3. Louver
4. Caster
5. Air outlet
6. Air inlet
7. Drainage nozzle
8. Remote controller
9. Exhaust duct assembly
10. Window sealing plate assembly

Control Panel and Remote Controller

Control Panel:

• 1. Power key: Press the key to turn ON/OFF the A/C.
• 2. Mode key: Press the key to choose cool, fan, and dry.
• 3. Temperature/time adjusting key: Press the key at cooling mode to increase/reduce the setting temperature; press it at timing mode to adjust time; press Up and Down keys simultaneously to switch Fahrenheit and Centigrade degree temperature.
• 4. Speed key: Press the key to choose high/low speed.
• 5. Timer key: Press the key at standby mode to set ON time. Press this key at ON mode to set OFF time.
• 6. Temperature/Time Display Window: Displays the adjusted temperature and time.
• 7. Remote controller receiving window: It is used to receive the signal of the remote controller.
• 8. °C/°F switching key: Press the key to switch °C and °F.
• 9. Sleep key: In the cooling mode, the sleep mode can be selected by this key.

Product Operation

Placement and Installation

Placement

• Place it at an even and dry place, and keep it at least 50cm away from its surrounding objects.

Installation:

• Screw the exhaust duct assembly into the air outlet behind the panel (counterclockwise).
• Insert the air exhaust hose into the window sealing plate, adjust the opening width of the window so that the window can match with the sealing plate properly; the length of the sealing plate is adjustable.

Incorrect Installation

• It is important to keep the exhaust duct smooth. Incorrect installation will affect the A/C's work.
• Prevent the exhaust duct from sharp bending.
• Ensure air can flow smoothly in the duct.

Warning: The exhaust duct is designed especially for this model. Do not replace or lengthen it; otherwise, it will result in failure.

Notice: Max. developed length of the exhaust duct is 1,500mm. It is better to shorten it while in use and keep it in a horizontal position during installation.

Operation Method

Cooling Mode

• When the A/C enters cooling mode automatically or cooling mode is selected after power ON, the cooling indicator lamp lights up.
• Press Up/Down key to adjust setting temperature (16°C~30°C) (60°F~86°F).
• Press Speed key to choose High/Mid/Low speed.

Fan Mode

• When pressing the mode key or choosing Fan mode by pressing the remote controller, the wind indicator lamp lights up.
• Press Speed key to choose High/Mid/Low speed.
• Temperature cannot be set.

Dehumidification Mode

• When pressing the mode key or choosing dehumidification mode by pressing the remote controller, the dehumidification indicator lamp lights up.
• Remove the dehumidification water wedge, insert the water manifold, and place the other end of the water manifold into the water vessel or drainage passage, as shown in the figure.
• After entering the dehumidification mode, if room temperature ≥17°C (62°F), the compressor is ON. Then control as follows: when room temperature ≤15°C (59°F), the compressor is OFF; when temperature increases to room temperature ≥17°C (62°F), the compressor will start again (in order to protect the compressor, it will be restarted 3 minutes later).
• In dehumidification mode, the fan is defaulted to run at low speed, and wind speed cannot be adjusted.
• Temperature cannot be set.

Note: When using the dehumidify function, remove the exit pipe components, otherwise, it will cause worse dehumidify performance and appear “FL” water full alarm.

Sleep mode (optional function)

• Under cool mode, pressing the sleep mode key on the remote controller or pressing the time key and down key together on the machine will start sleep mode with low wind speed, which cannot be adjusted. Pressing the sleep mode key again or pressing the time key and down key together on the machine will quit the sleep mode.
• If you press the wind speed key under the sleep mode, the screen will display “SL”.

Timer Mode

• In standby state, press the Timer key to set ON time. Press Up and Down keys to set ON time (0~24H), and the timer indicator lamp lights up.
• In ON state, press the timer key to set OFF time. Press Up and Down keys to set OFF time (0~24H), and the timer indicator lamp lights up.

Clean and Maintenance

Drainage Method

This product is equipped with an automatic water vaporization system. The condenser is cooled with the circulating condensing water, so as to improve cooling efficiency and save energy.

• If the internal vessel is full of water, the display screen will show “FL”, and the compressor stops working automatically. After power off, unscrew the water cover, pull out the water plug to drain off water, and it will become normal after being restarted.

Maintenance

Notice: In order to avoid electric shock, please turn off the A/C and unplug before maintenance or repair.

Cleaning

• Unplug before cleaning.
• Wipe with a soft semi-dry cloth. Do not use chemical reagents such as benzene, alcohol, or gasoline, etc.; otherwise, the surface of the A/C and even the whole A/C will be damaged.
• Prevent water from spattering into the A/C.

Filter Screen

• Wash the filter screen once every two weeks. If it is blocked by dust, the efficiency of the A/C will be reduced.
• Take out the air inlet grille and pull out the filter screen at both sides according to the direction shown in the figures.
• Put the filter screen into warm water (about 40°C or 104°F) with neutral detergent, and dry it in a shady place after cleaning.

Seasonal Cleaning

If the A/C will not be used for a long time:

• Pull out the water plug to drain.
• Run the A/C in fan mode for 2 hours until the inside is dry.
• Turn off the A/C and unplug.
• Wash the filter screen and reassemble it.
• Dismantle the exhaust duct and keep it properly.
• Cover the A/C with a plastic bag and place it in a dry place.

Common Failures and Diagnosis

Intelligent Error Detection

Fuse Parameters

• Voltage: 250VAC
• Current: 3.15A

Troubleshooting

In case of any of the following troubles, please contact professional maintenance personnel in time.

Notice: When there is any abnormality with the A/C, turn it off and unplug, and then contact professional maintenance personnel.

The above technical parameters are subject to change without notice.

Do not dispose of electrical appliances as unsorted municipal waste; use separate collection facilities. Contact your local government for information regarding the collection systems available.

If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being. When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for disposal at least free of charge.

Contact Us

VISIT US ONLINE:

• Have a question?
• Need service or repair?
• Want to leave a comment?

PyleUSA.com/ContactUs