Safety First
Before operating your new motorcycle, it is your responsibility to read and follow the operating and maintenance instructions in this manual, and adhere to basic safety rules for personal protection. Always know and respect the rules of the road and familiarize yourself with the contents of the accompanying RIDING TIPS booklet and the MOTORCYCLE HANDBOOK for your state.
Ensure proper operation of brakes, clutch, shifter, throttle controls, and check fuel and oil supply before starting the engine.
WARNINGS:
- Avoid aftermarket parts and custom front forks that can adversely affect performance and handling. Altering factory parts can lead to serious injury.
- Use only Harley-Davidson approved parts and accessories to maintain warranty.
- Stop the engine when refueling or servicing the fuel system. Do not smoke or allow open flames or sparks near gasoline due to its flammability and explosive nature.
- Refuel in a well-ventilated area with the engine off. Remove the fuel filler cap slowly. Do not overfill the tank, leaving air space for fuel expansion.
- Do not store the motorcycle with gasoline in the tank in areas with open flames, pilot lights, sparks, or electric motors.
- Engine exhaust contains chemicals known to cause cancer and birth defects.
- Do not run the motorcycle in a closed or confined area due to poisonous carbon monoxide gas.
- Ensure the jiffy stand is fully forward and locked with vehicle weight on it to prevent the vehicle from falling over.
- Always retract the jiffy stand fully before riding to prevent contact with the road surface and loss of control.
- Operate the motorcycle at moderate speeds and out of traffic until you are familiar with its operation and handling characteristics.
- Consider obtaining formal training from organizations like The Motorcycle Safety Foundation®.
- Travel at speeds appropriate for road and conditions, never exceeding the posted speed limit. Excessive speed can lead to loss of vehicle control.
- Pay strict attention to road surfaces and wind conditions. Reduce speed and guide the motorcycle with a relaxed grip if encountering unstable conditions. Do not brake abruptly or force the handlebar.
- Keep cargo weight concentrated close to the motorcycle and as low as possible. Distribute weight evenly and avoid loading bulky items too far behind the rider or adding weight to handlebars or front forks. Do not exceed specified load limits for saddlebags.
- Operate defensively, as a motorcycle offers less protection than a car in an accident. Always ride with the headlamp on.
- Wear an approved helmet, protective clothing, and suitable footwear. Bright or light colors enhance visibility. Avoid loose garments.
- Avoid contact with the exhaust system, which gets very hot. Wear protective clothing that covers legs.
- Instruct passengers on proper riding procedures.
- Do not allow inexperienced or unlicensed individuals to operate the motorcycle.
- Protect your motorcycle against theft by locking the steering head and removing the ignition key. Set the security alarm if equipped.
- Safe operation requires alert mental judgment and a defensive driving attitude. Avoid operating under the influence of fatigue, alcohol, or drugs.
- Adjust sound system volume to a non-distracting level.
- Maintain the motorcycle in proper operating condition, paying attention to tire inflation, tread condition, and wheel and steering head bearing adjustments.
- Do not operate the vehicle with the forks locked.
- Perform service and maintenance operations as indicated in the regular service interval table.
- Do not operate with loose, worn, or damaged steering or suspension systems. Contact a Harley-Davidson dealer for repairs.
- Regularly inspect shock absorbers and front forks, replacing worn or damaged parts.
- Use Harley-Davidson replacement fasteners.
- Ensure tires are properly inflated, balanced, and have adequate tread.
- Replace punctured or damaged tires promptly.
Rules of the Road
Follow these guidelines for safe riding:
- Keep to the right side of the road centerline.
- Always sound your horn, use turn signals, and exercise caution when passing. Never pass at intersections, on curves, or on hills.
- At intersections, yield the right-of-way to vehicles on your right.
- Always signal when preparing to stop, turn, or pass.
- Obey all traffic signs, including SLOW DOWN signs near schools and CAUTION signs at railroad crossings.
- When turning left, signal at least 100 feet before the turning point. Slow down, enter the intersection, and turn carefully.
- Never anticipate traffic lights; slow down and wait for the light to change. Never run through yellow or red lights.
- Watch for pedestrians, animals, and vehicles when turning.
- Signal before leaving the curb or parking area. Ensure your way is clear.
- Keep your license plate clean and visible.
- Ride at a safe speed consistent with highway type and conditions (dry, oily, icy, wet).
- Watch for debris like leaves or loose gravel.
- Adjust speed and driving habits according to weather and traffic conditions.
Accessories and Cargo
Harley-Davidson Motor Company does not test or recommend specific accessories. The rider is responsible for safe operation when installing accessories or carrying additional weight.
- Improper loading of cargo or installation of accessories can affect motorcycle stability and handling.
- Do not exceed the motorcycle's Gross Vehicle Weight Rating (GVWR) or Gross Axle Weight Rating (GAWR).
- GVWR is the total weight of the motorcycle, accessories, rider, passenger, and cargo. GAWR is the maximum weight per axle. These ratings are on the information plate on the frame down tube.
- Do not pull a trailer with a motorcycle, as it can cause tire overload, reduced braking efficiency, and affect stability and handling.
- Use caution with accessories like fairings, windshields, back rests, and luggage racks, as they can affect handling. Use only genuine Harley-Davidson items designed for the model.
- Do not use aftermarket parts and custom front forks that can adversely affect performance and handling.
- Only Touring Harley-Davidson Motorcycles are suitable for sidecar use.
Noise Control System
Tampering with or removing any noise control system component may be prohibited by law.
Vehicle Identification Number
The 17-digit Vehicle Identification Number (V.I.N.) is stamped on the steering head and on a label on the right front frame down tube. An abbreviated V.I.N. is on the left side crankcase. Always provide the full 17-digit V.I.N. when ordering parts or making inquiries.
Specifications
2007 Softail Models
- Engine: 2007 Twin Cam Models
- Number of cylinders: 2
- Type: 4-cycle, 45 degree, V-Type, air cooled
- Compression ratio: 8.9-1
- Bore: 3.75 in. (95.25 mm)
- Stroke: 4.38 in. (111.25 mm)
- Displacement: 96 cu. in. (1584 cc)
- Torque: 91 ft-lbs @ 3000 RPM (123 Nm @ 3000 RPM)
- Ignition timing: Not adjustable
- Battery: 12 volt, 19 amp/hr, sealed and maintenance free
- Spark plug type: HD-6R12
- Spark plug size: 12 mm
- Spark plug gap: 0.038-0.043 in. (0.97-1.09 mm)
- Spark plug torque: 12-18 ft-lbs (16.3-24.4 Nm)
Transmission: 2007 Softail Models
- Type: Constant mesh, foot shift
- Speeds: 6 forward
Sprocket Teeth: 2007 Softail Models
- Primary Engine: 34
- Clutch: 46
- Final Transmission: 32
- Rear wheel: 66* (*64 teeth on Japanese models)
Gear Ratios: 2007 Softail Models
GEAR | DOMESTIC AND INTERNATIONAL RATIO | JAPANESE MODELS RATIO |
---|---|---|
1st Gear | 9.312 | 9.030 |
2nd Gear | 6.421 | 6.226 |
3rd Gear | 4.774 | 4.630 |
4th Gear | 3.926 | 3.807 |