2007 Harley-Davidson Night Train Owner's Manual

Safety First

Before operating your new motorcycle, it is your responsibility to read and follow the operating and maintenance instructions in this manual, and adhere to basic safety rules. Always know and respect the rules of the road, and familiarize yourself with the accompanying RIDING TIPS booklet and your state's MOTORCYCLE HANDBOOK.

Before starting the engine, ensure proper operation of the brake, clutch, shifter, throttle controls, and check fuel and oil supply.

WARNINGS:

• Do not use aftermarket parts or custom front forks, as they can adversely affect performance and handling. Altering factory parts can lead to serious injury or death. Use only Harley-Davidson approved parts and accessories.
• Always stop the engine when refueling or servicing the fuel system. Do not smoke or allow open flames or sparks near gasoline, as it is highly flammable and explosive.
• Refuel in a well-ventilated area with the engine turned off. Remove the fuel filler cap slowly. Do not fill the fuel tank above the bottom of the filler neck insert to allow for fuel expansion.
• Do not store the motorcycle with gasoline in the tank in enclosed spaces where open flames, pilot lights, sparks, or electric motors are present.
• Engine exhaust contains chemicals known to cause cancer and birth defects.
• Do not run the motorcycle in a closed or confined area due to poisonous carbon monoxide gas.
• Ensure the jiffy stand is fully forward (down) with vehicle weight on it. If not, the vehicle can fall over.
• Always ensure the jiffy stand is fully retracted before riding to prevent loss of vehicle control.
• A new motorcycle requires a break-in procedure. Operate at moderate speeds and out of traffic until you are familiar with its operation.
• Consider formal training from organizations like The Motorcycle Safety Foundation® for correct riding techniques.
• Travel at speeds appropriate for road and conditions, never exceeding the posted speed limit. Excessive speed can lead to loss of vehicle control.
• Pay attention to road surfaces and wind conditions. If the motorcycle becomes unstable, reduce speed and guide it with a relaxed grip. Do not brake abruptly or force the handlebar.
• Keep cargo weight concentrated low and distributed evenly. Do not exceed maximum specified load in saddlebags.
• Wear approved protective gear, including a helmet, and bright or light-colored clothing for visibility. Avoid loose garments.
• Exhaust pipes and mufflers get very hot; wear protective clothing that covers legs to prevent burns.
• Instruct passengers on proper riding procedures.
• Do not allow inexperienced or unlicensed individuals to operate the motorcycle.
• Protect the motorcycle against theft by locking the steering head and removing the ignition key.
• Safe operation requires alert judgment and a defensive driving attitude. Avoid operating under the influence of fatigue, alcohol, or drugs.
• Adjust sound system volume to a non-distracting level.
• Maintain the motorcycle according to regular service intervals, paying attention to tire inflation, tread condition, and bearing adjustments.
• Do not operate with locked forks, as this restricts turning ability.
• Perform service and maintenance as indicated in the service interval table. Lack of maintenance can affect safe operation.
• Do not operate with loose, worn, or damaged steering or suspension systems. Contact a Harley-Davidson dealer for repairs.
• Regularly inspect shock absorbers and front forks, replacing worn or damaged parts.
• Use Harley-Davidson replacement fasteners. Aftermarket fasteners may affect performance.
• Ensure tires are properly inflated, balanced, and have adequate tread.
• Replace punctured or damaged tires.
• Do not exceed the Gross Vehicle Weight Rating (GVWR) or Gross Axle Weight Rating (GAWR).
• Do not tow a disabled motorcycle, as it can affect stability and handling.
• Do not pull a trailer with the motorcycle, as it can cause tire overload and reduce braking efficiency.
• Avoid direct contact of brake fluid with eyes; flush with water if contact occurs. Swallowing brake fluid may cause digestive discomfort.
• Batteries, battery posts, and terminals contain lead and lead compounds, which are known carcinogens. Wash hands after handling.
• Wheel weights on wheels without spokes may contain lead and lead compounds.
• Consult a Harley-Davidson dealer for any questions or problems. Failure to do so can aggravate issues, cause costly repairs, or lead to accidents.
• Ensure all required equipment is installed and in good operating condition.

Rules of the Road

Follow these guidelines for safe riding:

• Keep to the right side of the road centerline.
• Always sound your horn and use turn signals when passing. Never pass at intersections, on curves, or on hills.
• At intersections, yield to vehicles on your right.
• Always signal when preparing to stop, turn, or pass.
• Obey all traffic signs, especially slow down signs near schools and caution signs at railroad crossings.
• When turning left, signal at least 100 feet before the turn, move to the centerline, slow down, and turn carefully.
• Never anticipate traffic lights; slow down and wait for the light to change. Never run yellow or red lights.
• When turning, watch for pedestrians, animals, and other vehicles.
• Signal before leaving a curb or parking area and ensure your way is clear.
• Ensure your license plate is properly installed, visible, and clean.
• Ride at a safe speed consistent with highway conditions (dry, oily, icy, or wet).
• Watch for debris like leaves or loose gravel.
• Adjust speed and driving habits according to weather and traffic conditions.

Accessories and Cargo

Harley-Davidson Motor Company does not test or recommend accessories. The rider is responsible for safe operation when installing accessories or carrying weight.

• Improper loading of cargo or installation of accessories can affect motorcycle stability and handling.
• Do not exceed the motorcycle's GVWR or GAWR.
• Do not pull a trailer with the motorcycle.
• When equipping a motorcycle or carrying passengers/cargo, follow these guidelines:
• Travel at speeds appropriate for road and conditions.
• Reduce speed in poor driving conditions.
• Pay strict attention to road surfaces and wind conditions.
• Keep cargo weight concentrated low and distributed evenly.
• Do not load bulky items too far behind the rider or add weight to handlebars/front forks.
• Do not exceed maximum specified load in saddlebags.
• Do not overload luggage racks.
• Ensure cargo is secure and will not shift.
• Accessories that change the operator's riding position may affect reaction time and handling.
• Additional electrical equipment may overload the electrical system.
• Front and/or rear guards offer limited leg and cosmetic protection but are not intended for collision protection.
• Large surfaces like fairings and windshields can affect handling. Use only genuine Harley-Davidson items designed for the model.
• Do not use aftermarket parts or custom front forks.
• Only Touring Harley-Davidson Motorcycles are suitable for sidecar use.

Noise Control System

Tampering with or removing noise control system components may be prohibited by law.

Identification

Vehicle Identification Number

The 17-digit Vehicle Identification Number (V.I.N.) is stamped on the steering head and on a label on the right front frame down tube. An abbreviated V.I.N. is stamped on the left side crankcase.

Always provide the full 17-digit V.I.N. when ordering parts or making inquiries.

The document includes a V.I.N. breakdown for 2007 Softail Models, detailing each position and its meaning, along with V.I.N. model codes.

Specifications

2007 Softail Models

Engine: 2007 Twin Cam Models

Ignition System: 2007 Twin Cam Models

Transmission: 2007 Softail Models

Note: Specifications may vary by market. Refer to official certification documents or dealer for regulatory specifications.

Sprocket Teeth: 2007 Softail Models

*64 teeth on Japanese models

Gear Ratios: 2007 Softail Models