VK330 10.1" Touch Panel Quick Start Guide

Package Contents

• 1 VK330 10.1" Touch Panel
• 1 90° RJ-45 cable adapter
• 1 user instructions

Support and Documentation Notice

All information, documentation, firmware, software utilities, and specifications contained in this package are subject to change without prior notification by the manufacturer.

To reduce the environmental impact of ATEN products, documentation and software can be found online at http://www.aten.com/download/.

Technical Support: www.aten.com/support

ATEN Website: www.aten.com

A. Hardware Overview

Detailed view of the VK330 Touch Panel components.

Front View

The front of the device, displaying the touch panel screen.

Top View

Components visible from the top:

• 1. Touch Panel
• 2. Status LED
• 3. Function Button
• 4. Brightness +/-
• 5. Volume +/-

Rear View

Components visible from the rear:

• 6. Stereo Audio Out
• 7. Screw holes for panel plate
• 8. Speakers
• 9. Power Switch
• 10. Power Jack
• 11. For debugging purposes only
• 12. USB Micro-B port
• 13. USB Type-A port
• 14. LAN Port with PoE

Bottom View

Additional ports visible from the bottom.

B. Mounting the VK330

The VK330 Touch Panel supports desk mount, wall mount, or any third-party mounting accessory that is VESA compliant (75 mm x 75 mm).

Wall Mount

To mount the VK330 to the wall using an ATEN wall mount accessory, follow these steps:

1. Secure the wall plate to the wall using the wall anchors and screws.
2. Secure the panel plate to the VK330 using the M4 screws.
3. Slide the panel plate to the wall plate.

Note: Accessories for wall mount (VK302) and desk mount (VK304) installations are available for purchase. For more information, visit the VK330 product web page.

Desk Mount

The desk mount accessory provides a stable base for placing the VK330 on a desk.

C. Installation

1. Using the 90° RJ-45 cable adapter provided and an Ethernet cable, connect the unit to a PoE switch / injector to provide power and access to the network.
2. Put the Power Switch to ON. The status LED lights green.

Software Configuration

Adding Viewers to the ATEN Control System App

1. After switching the power to ON, wait for the ATEN Control System welcome page to appear.
2. Tap Start. The Download Viewer page appears.
3. Search for controllers and add Viewers that you have created. For more information about the ATEN Control System app, refer to the ATEN Control System User Manual.

Configuring the Network Settings

To configure network settings:

1. Press the Function button.
2. Tap Network & Internet > Ethernet > Ethernet IP Mode to configure the network settings.

Operation

• To return to the settings page, press the Function button once.
• To return to the ATEN Control System app from the settings page, tap Return to ATEN Control System App.